Mitsubishi Electronics WD-62526 manual Battery Installation, Care, Sleep Timer

Chapter 1. Television Overview 19

Remote Control, continued

	$"#-&%#4%57 7$3 %7%
1	57			"6%*0
					108&3	6
2
						7
3					(6*%&
						8
					4-&&1
						9
	427			27
					7*%&0	10
4	%&7*$& $)"//&- 70-6.&
						11
					"6%*0
						12
5
					.65&	13
14
15	&/5&3				$"/$&-	23
					46#
16	&9$)		"%+645		%&7*$&
	57 .&/6
17					.&/6	24
18	7$)*1	1*1101 1*1 $)			)0.&
						25
19
	'03."5 1*1 %&7*$&
					*/'0
20						26
21	3&$		4501		1"64&	29
22	$0//&$5					30
27						31
	3&83&7		1-":	'''8%
28						32

Figure 1. Remote Control Overview

Battery Installation

Figure 2

Installing the Batteries:

1.Remove the remote control’s back cover by gently pressing the ribbed tab in the direction of the arrow and sliding off the cover.

2.Load the batteries, making sure the polarities (+) and (-) are correct. For best results, insert the negative (-) side first.

"""
BMLBMJOF CBUUFSJFT

Figure 2. Installing batteries

Care

For Best Results from the Remote Control:

•Be within 20 feet of the equipment.

•Do not press two or more buttons at the same time unless instructed.

•Do not allow unit to get wet or become heated.

•Avoid dropping on hard surfaces.

•Do not use harsh chemicals to clean. Use only a soft, lightly moistened cloth.

•Do not mix new and old batteries.

•Do not heat, take apart, or throw batteries into fire.

•Use only AA alkaline batteries.

Hint: If the slide switch is set to TV and does not function, press POWER and 935 to reset the remote.

Sleep Timer

The Sleep Timer automatically shuts off the TV after the time delay you have set.

Setting the Sleep Timer:

1.Press SLEEP on the remote control.

2.Each additional press of SLEEP increases the time displayed by 30 minutes up until the maximum value of 120 minutes.

3.After five seconds of inactivity, the message will dis- appear.

4.Press SLEEP to view the time remaining before the timer turns the TV off.

Cancelling the Sleep Timer:

1.Press SLEEP to display the on-screen message.

2.Press SLEEP repeatedly until OFF is displayed.

Note: After five seconds of inactivity, the message box disappears.

Downloaded from www.Manualslib.com manuals search engine