Mitsubishi Electronics WD-65000 manual DTV Receiver with RGB Video Connections

Part II: Installation

Connecting a DTV Receiver

See Appendix B, page 59, for component video signal compatibility information.

For digital audio connections, see your DTV receiver and A/V receiver Own- er’s Guides.

TV back panel

DTV Receiver with RGB Video

Connections

(Figure 1)

1 Connect the outside antenna, cable, or satellite to ANT, or SATELLITE IN on the DTV receiver (see your DTV receiver’s owner’s guide for instructions, and cable compatibility).

Connect the RGB cables from the DTV receiver to the HIGH RESOLUTION INPUT GRBHV on the TV back panel. You may need to set the DTV input as- signment to RGB in the Assign Input

HIGH RESOLUTION INPUTS

	COMPONENT
PC - 1	480i	/ 480p
	1	2
VGA / SVGA / XGA
		Y
AUDIO-L		Pr
60 Hz
AUDIO-R		Pb

2	Y/G	H	AUDIO-L
2	Pr/R	AUDIO-L	3(MONO)
		V	3AUDIO-R
2	Pb/B	AUDIO-R

DTV

1080i / 720p / 480i / 480p

6

5

IR - EMITTER

1 2 3 4 MON

White

Red

INPUT	O
ANT-A	LOOP
	OUT

Menu, page 33.

	DTV Receiver		TV Back Panel
2	G (green)	=	Y/G
3	R (red)	=	Pr/R
4	B (blue)	=	Pb/B

If the DTV receiver has outputs for H and V sync, connect as listed below

(DO NOT connect if DTV receiver uses “Sync on Green”):

Connecting a DTV

		6
		5 AUDIO			CAUTION
					RISK OF ELECTRICAL SHOCK
					DO NOT OPEN
	G	L	VCR
2			CONTROL3
					OUT TO TV
2	R	R	3		CH 3
				DIGITAL	CH 4
	RF	H		AUDIO OUT
2
	B

PHONE JACK REMOTE V S-VIDEO IN FROM ANT SATELLITE IN

Figure 1. Connecting the DTV receiver with RGB video connections.

5	H (horizontal sync)	=	H
6	V (vertical sync)	=	V
7	Connect the L (left) and R (right) audio
	cables from the DTV receiver and to DTV
	AUDIO on the TV back panel.
	To utilize the benefits of a digital A/V re-
	ceiver, connect your DTV receiver’s digital
	audio out to a digital input on your digital
	A/V receiver.

Receiver

21