Mitsubishi Electronics WD-65000 manual Programming the Remote, DVD/LD Player Codes

Part III : Setup

Programming the Remote Control: To Control Other A/V Products

CABLE/DBS/DTV VCR DVD		POWER
TV	AUDIO

1 2

3	DVD/LD Player Codes
	DVD/LDP brand	Code to enter:	If your
	Mitsubishi (DVD)	003	DVD
	Mitsubishi (LD)	016, 017	code is not
			listed here,
	Panasonic	250
			please see
	Pioneer DVD (LD)	252 (, 016, 017)
			page 60 for
	Sony	254
			a complete
	Toshiba	253
			listing.
	To reset to default code, enter 000

Figure 4. Programming the remote to control your DVD/LDP.

After entering the correct codes in each position of the remote control, use the slide switch to select which product will respond when an operational button is pressed. If you enter a code from the AUDIO chart while the slide switch is set to TV, the volume and mute functions change to match the A/V receiver. This is useful when using an A/V receiver with the TV all the time. In all other cases, only one of the below devices is allowed for each slide switch position.

TV position:

TV

A/V receiver (volume and mute only)

Cable/DBS/DTV position:

Cable box

Satellite receiver

DTV receiver

Programming the Remote

CABLE/DBS/DTV VCR DVD			POWER	VCR position:
TV		AUDIO		VCR
1			2
3	A/V Receiver Codes			DVD position:
Audio brand		Code to enter:	If your	DVD
Mitsubishi A/V receiver		Set M-VR1000 or M-VR800 to 015	audio	LD Player
			code is not
		Set M-VR900 or M-VR700 to 010
			listed here,
Mitsubishi CD player		010, 011
			please see	Audio position:
Denon		234, 235, 236
			page 60 for
Kenwood		200, 208	a complete	A/V receiver
JVC		232, 233
Onkyo		209, 214	listing.	Mitsubishi CD player [If you have a Mitsubishi A /V
Pioneer		205, 207		receiver, the audio position may be used in conjunction with
Sony		222
				select Mitsubishi CD players. Your audio position must be
Yamaha		201, 202
				programmed to either 010 or 011. Plug the CD player power
To reset to default code, enter 000
				cord into a switched outlet on the back of your A /V receiver.
Figure 5.	Programming the remote to control your			Pressing the POWER button will then turn on your A/V receiver,
				in turn, turning on your CD player. On select CD players, the
A/V receiver.
				transport controls (FF, PLAY, REW, etc.) in the audio position
				will operate the CD player.]

Control: To Control Other A/V Products

If the slide switch is set to TV when you enter an A/V receiver code, VOL- UME and MUTE will control the A/V receiver rather than the TV. To return volume and mute control to the TV, set the slide switch to TV, press and hold POWER and enter 000.

Some manufacturers may change their products, or they may use more than one remote control system. If this is the case, your remote control may not be able to operate your VCR, DVD, cable box, satellite receiver, or A/V receiver.

27