One for All OARN05G warranty Learning From Your Original Remotes

Learning From Your Original Remotes

1.Place your original remote and the learning remote on a flat surface as shown below. Point the top of your original remote at the top of the learning remote. The IR LED on the original remote should be pointing directly at the learning remote’s learning sensor, located on the top of the remote. The remotes should be 1–2 inches apart.

1–2”

English

2. On the learning remote, press and hold

the device key you want to use the learned function in (the POWER key turns on and remains on). While holding down the device key, use your other hand to press and hold the RECORD key (the POWER key illumination turns off).

3. Wait until the POWER key turns on and stays on. Then release both keys. The remote is now in Learning mode.

4. On the learning remote, press the key you want to use for the learned function. The illuminated POWER key blinks once, then remains on.

5.On the original remote, press and hold the key you want to teach to the universal remote. Wait until the POWER key on the learning remote blinks once, then release the key on the original remote. The learning remote has finished learning this key.

Note: If a problem occurs during the Learning process, the illuminated POWER key blinks four times, but the unit remains in the Learning mode. If this occurs, adjust the distance between the remotes slightly and repeat from step 4.

6.To learn another key for this device mode: Repeat steps 4 and 5 for the key you want to learn.

To learn keys in a different device mode: Repeat steps 2–5 for the next device mode.

To save learned keys and exit learning: press the SLEEP key on the learning remote.

Learning Tips

•Make sure the batteries in both the learning and original remote(s) are fresh.

•Incandescent or low-energy light can cause interference with IR transmissions. When using the Learning function, keep remotes at least three feet away from such light sources.

•Make sure the original remote is in the same mode as the universal remote so that the Learned key is assigned to the correct mode.

•You cannot learn any commands under the MACRO, SLEEP, or BACKLIGHTING keys.

•If you use the VOL+/- keys to learn new functions, the volume control will not adjust the volume in the Volume

Punch Through mode.

•To exit Learning mode at any time, press the SLEEP key.

•The remote exits Learning mode if it has run out of memory to store new learned keys.

•To ensure that your units are compatible and to increase your familiarity with the Learning process, experiment by learning two or three keys initially. Then, carry out a Master Clear before learning all the desired functions from your original remote.

13