3.Press and hold the device key you want to program (the POWER key illuminates). While you’re holding down the device key, use your other hand to press and hold the remote’s POWER key at the same time (the POWER key turns off).
4.Wait until the POWER key comes on and stays on. Then release both keys.
5.Look at the numbers you circled for your device’s brand code. Press those numbers on the remote keypad.
Note: For
6.Point the remote directly at the front panel of the device you want to control. Press SKIP FWD on the remote and wait 2 seconds. The remote is testing a single code for your device’s brand.
Did your device turn off?
YES: Press the OK key to store the code. You’re done! You’ve programmed this device key.
NO: Press SKIP FWD again. The remote tests the next code for your brand.
Keep pressing SKIP FWD every 2 seconds until your device turns off. When it does, press OK.
NOTES: Throughout the programming of each key, be sure to keep the remote pointed at the IR sensor of the device you are currently programming the remote to control.
Test the remote with the device to make sure the device key is programmed with the correct code for maximum functionality. If some features don’t work, try a different code. See the “Testing the Code for Maximum Functionality” section below for more information.
During the Brand Code Search, the remote ignores keypresses that aren’t part of the search.
The search times out after two minutes (the POWER key blinks four times and the last programmed code under that device key is retained).
The POWER key blinks four times when the remote has gone through all the codes. The remote exits the Brand Code Search. If your device hasn’t turned off yet, try a different search method.
Testing the Code for Maximum Functionality
1.Try a variety of the device’s functions with the remote. If some device features don’t work, go to the next step to try a different code.
2.Repeat the Brand Code Search from the beginning. When the device turns off for the first time, don’t press the OK key, which would store the same code. Instead, with the unit now off, continue to press the SKIP FWD key repeatedly until the unit turns back on.
3.Once the unit turns back on, you have found another code that operates the device. Press the OK key.
4.Test the key’s functionality again by attempting to control a variety of the device’s functions. If the code that has been stored controls the majority of the device’s functions, programming is complete. If the code stored does not give maximum functionality, try another code.
English
5