Initial Setup
Adjusting CRT Color Convergence (continued...)
Manual
| Press the MENU button |
π† | To CONVERGENCE |
è | To Enter |
π† | To choose MANUAL |
è | To Enter |
If all the lines are white, no convergence adjustment is necessary. If not, you need to perform the manual color convergence below.
Select the location you want to adjust by using the number buttons on the remote control.
You can select any of the 81 points.
Press the SELECT button to change the color of the
box 
to the color of the cross you wish to adjust (red or blue).
π†√® Adjust the position of the cross.
Adjust the three color crosses until they overlap and appear as a single white cross.
Press the OK button
Notes:
•When you adjust the convergence, make sure you start with the center position (position 5), and work your way around radially for best results.
•When you make the adjustment in the center (position 5), you are making the adjustment for the whole screen. In other positions, you are making the adjustment only in that area.
•You can reset the adjustment if you do not like the results. See below.
•If you perform AUTO CONVERGENCE after performing MANUAL CONVERGENCE, your manual convergence you performed will be cancelled.
Reset
RESET resets all convergence adjustments to the factory default settings.
Press the MENU button
π† To CONVERGENCE √® To Enter
π† To RESET √® To enter
When the adjustment is reset, it will return to what you were watching.
37