VIVOTEK - A Leading Provider of Multimedia Communication Solutions
Hardware Reset
Ext. Int.
Mic. In
12VDC | Ethernet | Ext. I/O |
Audio
Out Ext. Int.
There is an indented reset button on the side panel of the Network Camera. It is used to reboot the Network Camera or restore the Network Camera to factory default. Sometimes rebooting the Network Camera could set the Network Camera back to normal state. If the problems remain after rebooted, restore the Network Camera to factory default and install again.
Reset: Press and release the indented reset button with a needle. Wait for the Network Camera to reboot.
Restore: Press the indented reset button continuously for over 5 seconds until the status LED rapidly blinks red and green simultaneously. Note that all settings will be restored to factory default.
6 - User's Manual
