Clarion K20 manual Rapid resume logic, Panic mode

1. Turn the ignition on.
2.	Turn the ignition off.
3.	Press and release the Valet®
	switch within 10 seconds.	DRW-35

The status LED will light steadily if you are entering Valet® Mode and will turn off if you are exiting Valet® Mode.

➜

panic mode

If you are threatened in or near your vehicle, you can attract attention by triggering the system with your transmitter. Just

press for two seconds to enter Panic Mode. In Panic Mode, the horn will honk (if connected) and the parking lights will flash

for 30 seconds. To stop Panic Mode at any time, press on the transmitter again.

note: In order for Panic Mode to be effective, the vehicle’s horn (or optional siren) as well as the vehicle's parking lights must be connected.

rapid resume logic

This Pro Security system will store its current state to non-volatile memory. If power is lost and then reconnected, the system will recall the stored state from memory. This means if the unit is in Valet Mode and the battery is disconnected for any reason, such

© 2 0 0 6 d i r e c t e d e l e c t r o n i c s , i n c . 9