Giantec 2000 manual Version

Page 10

Tracer 2000 DVR user manual

2.2. Connect Camera Cable to BNC connector

2.3.Connect to LAN connector: Plug RJ-45 connector to LAN Port

2.5.1Insert RJ-45 cable to network LAN socket on the rear.

2.5.2Connect Serial port modem to serial connector (COM1) and through Dial-in function to connect to Internet.

Version 3.0

Page 10 of 36

Image 10

Contents User’s Manual Contents Chapter System HDD Installation Guide Copyright Notice Chapter Feature Package Packing ListInstallation ※Remove and clean up Air Filters monthly is essentialIndicator Connect VGA MonitorVersion Connect to Printer Port option Power Connector Internal Jumpers and Connectors Pin assignmentInternal USB connector USB2 Power Switch for ATX power supply JP1Reset/LED/Speaker JP1 Power connector P1CPU FSB Select JP4 HDD Connector IDE1FAN control FAN1 Parallel/Printer connector PRN Video Input J2General Purpose Input / Output J3 Infra-Red IRPCI bus pin assignment Component SideAudio Input connector External Connector CRT Display Connector VGAGpio connector USB connector COM 1 Connector RS-232 Connector COM1 COM2 ConnectorEthernet connector RJ-45 Drawing of Ethernet connector RJ-45 ConnectorsZ Setting RS485 RS422 RS232Setup Pages IntroductionStandard Cmos Features EGA/VGAAdvanced Bios Features CdromAdvanced Chipset Features Integrated Peripherals Button onlyPower Management Setup DpmsPnP / PCI Configuration PC Health Status Frequency/Voltage ControlSave & Exit Setup Load Optimized DefaultsSupervisor / User Password Exit Without SaveSystem HDD Installation Guide Take off the upper cover and remove the screws Remove HDD Tray, and install HDD properly Version Assemble the upper cover and the screws