Giantec 2000 manual Power Connector

Page 12

Tracer 2000 DVR user manual

3. POWER CONNECTOR

3.1. Connect power cord (110V~240V auto switch) into the power socket.

Press “I” to start up system...

Pushes switch “I” to turn it on.

Version 3.0

Page 12 of 36

Image 12

Contents User’s Manual Contents Chapter System HDD Installation Guide Copyright Notice Chapter Feature Package Packing ListInstallation ※Remove and clean up Air Filters monthly is essentialIndicator Connect VGA MonitorVersion Connect to Printer Port option Power Connector Internal Jumpers and Connectors Pin assignmentPower Switch for ATX power supply JP1 Reset/LED/Speaker JP1Internal USB connector USB2 Power connector P1HDD Connector IDE1 CPU FSB Select JP4FAN control FAN1 Parallel/Printer connector PRN Video Input J2General Purpose Input / Output J3 Infra-Red IRPCI bus pin assignment Component SideExternal Connector CRT Display Connector VGA Audio Input connectorGpio connector USB connector COM 1 Connector RS-232 Connector COM1 COM2 ConnectorEthernet connector RJ-45 Drawing of Ethernet connector RJ-45 ConnectorsZ Setting RS485 RS422 RS232Setup Pages IntroductionStandard Cmos Features EGA/VGAAdvanced Bios Features CdromAdvanced Chipset Features Integrated Peripherals Button onlyPower Management Setup DpmsPnP / PCI Configuration PC Health Status Frequency/Voltage ControlLoad Optimized Defaults Supervisor / User PasswordSave & Exit Setup Exit Without SaveSystem HDD Installation Guide Take off the upper cover and remove the screws Remove HDD Tray, and install HDD properly Version Assemble the upper cover and the screws