Finishing
1 Switch off the power of the connected equipment
2 Switch off the power of the projector
Press the STANDBY button on the remote control or the projector.
STATUS STANDBY
(button on main unit) | OK ? |
| Power Off |
|
|
|
|
The [Power Off] display appears.
When the level gauge reaches maximum, the projec- tion screen will go off (in about 5 seconds) and the projector will enter the
Note:
•The operation can be cancelled by pressing a but- ton other than the STANDBY button.
• One more press of the STANDBY button will switch | STATUS STANDBY | STATUS STANDBY | STATUS STANDBY |
off the power. |
|
|
|
The STANDBY indicator changes to flashing amber | Lit green | Flashing amber | Lit amber |
and lights a steady amber after about 90 seconds | (Approximately | Standby | |
| 90 seconds) | mode | |
(when the unit enters the standby mode). |
| ||
|
|
|
3 Unplug the power cable
Check that the STANDBY indicator is lit in amber and then unplug the power cable.
The STANDBY indicator will go off when the power cable is unplugged.
4 Turn the lens cover counterclockwise until it stops.
DNATS
SUTATS
1
CLOZE
The lens cover will stop with a click.
ATST
2
Unplug & Go function
When the power cord is unplugged directly after the power is turned off, the internal power supply is used to keep the cooling fan turning and cool the lamp, so the projector can be moved immediately.
•It may be more difficult to turn the lamp back on if it has been cooled with the power cord unplugged.
•Do not place the projector in a bag, etc., while the cooling fan is turning.