Giantec 2000 manual Feature

Page 6

Tracer 2000 DVR user manual

FEATURE

The TRACER2000 comes with the following hardware devices:

Control panel with IR receiver

One10/100Mbps RJ-45 Ethernet Port

One RS 232 and one RS232/422/485 selectable interface

One VGA Connector

One speaker out

Two USB Ports

Two 3.5” HDD Supported

Four Audio-in Ports

Eight GPIO Ports

Remote Commander

Working temperature: 0 ~ 45 °C

Storage temperature: -10 ~ 65 °C

Relative humidity: Maximum 85%, non-condensing

Power requirement: AC 100 ~ 240V, 50 / 60 Hz, 150W maximum

Dimension: 265 mm (D) x 321mm (W) x 103mm (H)

Weight: 5Kg

Version 3.0

Page 6 of 36

Image 6
Contents User’s Manual Contents Chapter System HDD Installation Guide Copyright Notice Chapter Feature Package Packing ListInstallation ※Remove and clean up Air Filters monthly is essentialIndicator Connect VGA MonitorVersion Connect to Printer Port option Power Connector Internal Jumpers and Connectors Pin assignmentInternal USB connector USB2 Power Switch for ATX power supply JP1Reset/LED/Speaker JP1 Power connector P1HDD Connector IDE1 CPU FSB Select JP4FAN control FAN1 Parallel/Printer connector PRN Video Input J2General Purpose Input / Output J3 Infra-Red IRPCI bus pin assignment Component SideExternal Connector CRT Display Connector VGA Audio Input connectorGpio connector USB connector COM 1 Connector RS-232 Connector COM1 COM2 ConnectorEthernet connector RJ-45 Drawing of Ethernet connector RJ-45 ConnectorsZ Setting RS485 RS422 RS232Setup Pages IntroductionStandard Cmos Features EGA/VGAAdvanced Bios Features CdromAdvanced Chipset Features Integrated Peripherals Button onlyPower Management Setup DpmsPnP / PCI Configuration PC Health Status Frequency/Voltage ControlSave & Exit Setup Load Optimized DefaultsSupervisor / User Password Exit Without SaveSystem HDD Installation Guide Take off the upper cover and remove the screws Remove HDD Tray, and install HDD properly Version Assemble the upper cover and the screws