Giantec 2000 manual General Purpose Input / Output J3, Infra-Red IR

Page 17

Tracer 2000 DVR user manual

General Purpose Input / Output (J3)

	2	16
	1	15
Pin no.	signals	Pin no.
1	GPIO-0	2
3	GPIO-1	4
5	GPIO-2	6
7	GPIO-3	8
9	GPIO-4	10
11	GPIO-5	12
13	GPIO-6	14
15	GPIO-7	16

signals

Audio IN3

AGND

Audio IN2

AGND

Audio IN1

AGND

Audio IN0

GND(for GPIO)

Infra-Red (IR)

1	5

Pin no.	signals
1	VCC
2	IRRX
3	GND
4	IRTX
5	CIRRX

Version 3.0

Page 17 of 36

Image 17

Contents User’s Manual Contents Chapter System HDD Installation Guide Copyright Notice Chapter Feature Packing List Package※Remove and clean up Air Filters monthly is essential InstallationConnect VGA Monitor IndicatorVersion Connect to Printer Port option Power Connector Pin assignment Internal Jumpers and ConnectorsReset/LED/Speaker JP1 Power Switch for ATX power supply JP1Internal USB connector USB2 Power connector P1FAN control FAN1 HDD Connector IDE1CPU FSB Select JP4 Video Input J2 Parallel/Printer connector PRNInfra-Red IR General Purpose Input / Output J3Component Side PCI bus pin assignmentGpio connector USB connector External Connector CRT Display Connector VGAAudio Input connector COM2 Connector COM 1 Connector RS-232 Connector COM1Connectors Ethernet connector RJ-45 Drawing of Ethernet connector RJ-45RS485 RS422 RS232 Z SettingIntroduction Setup PagesEGA/VGA Standard Cmos FeaturesCdrom Advanced Bios FeaturesAdvanced Chipset Features Button only Integrated PeripheralsDpms Power Management SetupPnP / PCI Configuration Frequency/Voltage Control PC Health StatusSupervisor / User Password Load Optimized DefaultsSave & Exit Setup Exit Without SaveSystem HDD Installation Guide Take off the upper cover and remove the screws Remove HDD Tray, and install HDD properly Version Assemble the upper cover and the screws