Motion


		(MOTION)
	SEN	MD-NUM RE DET
CAM1	70	03	64	ON	AREA
CAM2	70	03	64	OFF	AREA
CAM3	70	03	64	ON	AREA
CAM4	70	03	64	ON	AREA
	MOTION RECORD : ON
	DAY	START		END
	DAILY	00 : 00	00 : 00

1. SEN (SENSITIVITY)

Sets the sensitivity of the pixel-based Motion Detection feature from 1 to 99. The highest sensitivity setting is 01, the lowest sensitivity setting is 99.

The default setting is 70.

2. MD-NUM (MOTION DETECTION NUMBER)

Sets the number of targets of the motion detection to occur in order to trigger an Alarm (from 1-99 target areas).

Note: MD-NUM cannot be less than the number of targets set in the AREA.

3. RE (REFERENCE)

Set the Reference image to which the current screen is compared (from 1-99). For example, the value 64 would compare the current image to the 64th previous screen image. The higher value may increase the sensitivity.

4. DET (DETECTION)

The motion detection on each channel can be turned to be

ON or OFF individually.

5. AREA

Press the ENTER button on this option to set the Pixel-based Motion Detection Area for each channel. Red targets represent where the target is (Figure 1-1). Green targets represent the Motion Detection Area(Figure 1-2), and Purple targets represent motion currently taking place (Figure 1-3). After stopping the detection, the color of target will be green (Figure 1- 4).

To modify the Motion Detection Area, use the following controls:

ZOOM: turn the selected target ON/OFF.

▲▼◄►: navigates between targets

-: turns all targets on the screen ON/OFF

+: turn all targets in the selected row ON/OFF

Note: When the “DET” (DETECTION) setting is “ON”, you must set the motion detection area or it won’t be triggered.