Maxtor HVR-04E manual FCC Compliance Statement

Page 2

FCC Compliance Statement

Caution: Any changes or modifications in construction of this device which are not expressly approved the party responsible for compliance could void the user's authority to operate the equipment.

NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications, However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

-Reorient or relocate the receiving antenna.

-Increase the separation between the equipment and receiver.

-Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.

-Consult the dealer or an experienced radio/TV technician for help.

CAUTION

1.Danger of explosion if battery is incorrectly replaced. Replace only with the same or equivalent type.

2.Disposal of used batteries according to the general recommendations against the environmental pollution.

3.Do not throw the batteries into a fire, and do not heat, short-circuit or attempt to disassemble the batteries.

4.Do not attempt to recharge the batteries.

Image 2
Contents Installation Guide HVR-04EFCC Compliance Statement Important Notice HVR-04E Table of Contents Table of Contents HVR-04E Appendix #1 What is HVR-04E? Key featuresSupplied Accessories OverviewDescription & Function HVR-04E FrontHVR-04E Rear Connecting & Running HVR-04E Connecting cameraConnecting Monitor Connecting AudioInstallation and Connection Supplying Power Using menu Running OSD menuDialogue Box to Edit a Word Set ID of HVR-04E Setting remote controllerSetting remote control DIP switch Selecting HVR-04E Installation and Connection HVR-04E Configuration Basic Configuration Advanced ConfigurationInstallation and Connection HVR-04E HVR-04E Basic Setting Viewing ImageSetting Date & Time Time ZoneTime Format Setting Recording Condition Configuration Status Quality Connecting and Configuring Sensor Connecting Sensor InputSetting Sensor at OSD menu Connecting & Configuring Relay Out Connecting Relay OutConfiguring Relay Out Connecting External Device with Serial Port Connecting Text Input Device ATM / POS / Access ControlConnecting & Configuring Serial Ports for Pan/Tilt/Zoom Connecting Serial PortConfiguring Serial Port Connecting USB Device Trimming WireInstallation and Connection IEEE1394 Bay Connecting External StorageConnecting IEEE1394 Device Available HDDRegistering & Formatting HDD Connecting Ethernet Network Monitoring & ManagingConfiguring HVR-04E’s Network Information Using DVR Manager PC System Requirements for running DVR ManagerHVR-04E Installation and Connection Configstation Uninstalling DVR ManagerMonitor PlaybackAppendix Compatible HDD Appendix #1 Installing and Replacing internal HDDInstalling & Replacing Appendix Installing single HDD Installing 2 HDDs Assemble the top cover HVR-04E Appendix Video type / impedance setup switch Appendix #2 Video InputPreparation Appendix #3 Using CD-ROMComponents of CD- ROM disc Reading manual of CD-ROMImage Compression Appendix #4 SpecificationGeneral NetworkEnvironment Data Backup/Expansion/CopyDisplay Input/OutputElectricity PTZ ControlOthers Mechanical Hunt Electronic USA, Inc