Philips SWW1810 user manual Technical data, Supported resolution, Product specifications

Page 15

7 Technical data

Supported resolution

Video format

Resolution

timings

 

Primary CEA

-

video timing

 

480p

640x480p @ 59.94/60Hz

480p

720x480p @ 59.94Hz

480p

720x480p @ 60Hz

576p

720x576p @ 50Hz

720p

1280x720p @ 50Hz

720p

1280x720p @ 59.94/60Hz

1080i

1920x1080i @ 50Hz

1080i

1920x1080i @ 59.94/60Hz

1080p/60

1920x1080p @ 50Hz

1080p/60

1920x1080p @ 59.94/60Hz

 

 

Secondary CEA

 

video timing

 

1080p/24

1920x1080p @ 23.98/24Hz

1080p/24

1920x1080p @ 25Hz

1080p/24

1920x1080p @ 29.97/30Hz

Product specifications

General specification

Video resolution

HDMI input: 1080p, 1080i, 720p, 576p, 480p Supported audio formats:

Digital audio: up to 6 Mbps AC3 and DTS

Analog audio: 32-96 KHz and 16-24 bits per audio sample

Transmission distance:

Maximum 65 feet (19.7 meters)

Antennas:

High performance internal antennas Operating frequencies:

5.15-5.25/5.725-5.825 GHz

Power supply:

Input: AC 100~ 240V

Output: DC 5V, 2A Operating temperature: 0~40°C/32~104°F

Transmitter interfaces

A/V interfaces

HDMI input:Two (Type A)

Control signal interfaces

IR blaster extender: 2.5mm jack Power interface

Power input: 5V DC jack Switches

Top power switch: One

Top source switch: One LEDs

Power LED: 1 x blue/red LED

Source LED: 2 x blue LED Dimensions

194.8 x 146.8 x 31 mm (W x L x H)

Receiver interfaces

A/V interfaces

HDMI output: One (Type A) Control signal interfaces

IR sensor: available Power interface Power input: 5V DC jack Switches

Top power switch: One

Top source switch: One LEDs

Power LED: 1 x blue/red LED

Source LED: 2 x blue LED

Signal quality status: On-screen display Dimensions

194.8 x 146.8 x 31 mm (W x L x H)

E n g l i s h

EN 15

Image 15
Contents Register your product and get support at SWW1810 Page Contents Important Safety Instructions SafetyApparatus shall not be exposed to dripping or splashing Congratulations on your purchase and welcome to Philips What is in the boxOverview TransmitterReceiver Remote control PowerInfo Installation Connect the transmitter to your HD devicesConnect the receiver to the Hdtv set Connect the IR blaster and IR sensor extender cables Install remote control batteriesCH1 Turn on the power of yourOn screen display on Hdtv HdmiSelect the source on the transmitter Activate the wireless linkSwitch on the transmitter and receiver Establish the link between the transmitter and receiverMount your receiver Mount your receiver on the wallSelect a spot near the Hdtv Mount your receiver on the back of the Hdtv Technical data Supported resolutionProduct specifications Reorient or relocate the receiving antenna Important NoteRadiation Exposure Statement Disposal of your old product and batteries RecyclingFrequently asked question Power LED onReceiver is not lit up in red Standby mode Solid blue power LED + quick and flashing source LEDDistance What do I do? Matches the resolution of your HdtvMake sure that the TV volume is adjusted correctly If the picture quality is poor20 EN Page Koninklijke Philips Electronics N.V