Philips SWW1810 user manual Connect the IR blaster and IR sensor extender cables

Plug the IR blaster extender cable into the IR OUT blaster extender jack of the transmitter.

Extend and stick the IR blaster extender cable onto the front panel of the HD device.

After the IR blaster extender cable is connected to the transmitter, you can control your HD device with the remote control. Make sure that the remote control points to the receiver.

If the distance between the receiver and receiver has obstruction (e.g. the receiver is mounted at the back of the HDTV), plug the IR sensor extender cable into the IR IN jack of the receiver.

Connect the IR blaster and IR sensor extender cables

Tip

•• If you cannot use the remote control of your device, follow the steps in this section to connect the sensor extender cables .

5 Extend and stick the IR sensor extender cable onto the front side of your HDTV.

Note

•• The IR blaster support 47KHz remote signal protocol, while the IR sensor supports 36KHz - 56KHz (NEC, RC5, RC6) remote signal protocol.

Connect the infrared blaster or sensor extender cables if necessary.

1

2

3

4

Install remote control batteries

Caution

•• Risk of explosion! Keep batteries away from heat, sunshine or fire. Never discard batteries in fire.

•• Risk of decreased battery life! Never mix different brands or types of batteries.

•• Risk of product damage! When the remote control is not used for long periods, remove the batteries.

AAAAAA

1 Open the battery compartment.

2 Insert two AAA batteries with correct polarity (+/-) as indicated.

3 Close the battery compartment.

10EN