Philips DVDR1500 warranty Diagnosis program, System limitations, Instructions

Page 60

English

 

 

 

 

 

 

 

Diagnosis program

 

 

If the Recorder is still faulty you can start the Diagnosis

 

Program in the Recorder.

 

You can operate the Diagnosis Program by following

 

these instructions step by step.

 

 

 

 

 

 

 

 

 

Instructions

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

1Unplug the power cord of the Recorder.

2Press and hold the 2 PLAY button while you reconnect the power cord of the Recorder.

On the display BUSY appears with number. The number is 0 when the test is done. Release the

2 PLAY button.

After a few minutes, the message changes from BUSY to FAIL or PASS.

3If FAIL appears on the display, there is apparently a failure in your Recorder. Your Recorder should be repaired. Consult your dealer or the Philips Customer Care Center for the nearest Authorized Service Center in your country. The phone number is in your warranty booklet.

4If PASS appears on the display, there is apparently no failure in your Recorder in this case, one failure can be caused by incorrect interpretation of the operating instructions, a wrong disc in use, or incorrect connections. Consult your dealer or the Philips Customer Care Center for further assistance in solving the problem.

5Unplug the power cord, then reconnect it to a power source and use the DVD Recorder again as usual.

System limitations

A DVD+RW disc may not play on certain DVD Video players.

A DVD+RW disc recorded on a different type or brand of Recorder can play, but may not provide all features commonly available to it, such as the on-screen disc bar, the disc settings menu, the title settings menu, and editing.

Refer to ‘Adapt disc format.’ If the disc is erase- protected, the status cannot be changed.

When using manual recording, the DVD Recorder will advise you before adapting the format of the disc or removing non-video data (See ‘Before you start recording’.) When using timer recording, however, the DVD Recorder will always start to record, unless the disc is write-protected. Menus, edits and other data recorded on a different device (e.g. a PC) may be lost.

Because of the Variable Bit Rate, a title map takes up less or more space than the overwritten title, even though the duration is the same. As a result, part of the original title may remain, or part of the next title may be lost. The maximum deviation is five minutes.

When you connect a remote control to the IN RC6 Remote Control Input on the back of the Recorder, the first signals from the remote control may be lost.

After a power interruption during recording, the Index Picture Screen may not match the actual video content on the disc. The last recorded title may be lost.

60TROUBLESHOOTING

Image 60
Contents For fast help, call us first Page Warranty Verification Important safety instructions General InformationLaser safety For Customer UsePage English Françaisx Español English Contents Operation RecordingPlayback Access control Managing disc contentTroubleshooting GlossaryIntroduction DVD RecorderBox contents PlacementCleaning discs Remote controlInstallation Connecting to the antenna or Cable TV signalConnecting to a TV Connections back of your DVD RecorderConnecting to audio Equipment Video Y/C connectionVideo Cvbs connection Digital Multi-channel soundConnecting to other equipment optional Connecting to a receiver equipped with Dolby Pro LogicConnecting to a TV with a Dolby Pro Logic decoder Connecting to a receiver with two channel analog stereoPower supply Connections Front Your DVD Recorder optionalCamcorder connection First time setup Initial setup Manual settingMenu language Audio languageTV Shape Automatic TV Channel SearchSwitching on Quick startManual recording Timer programming Timer programming with ’VCR Plus+’Timer programming without VCR Plus+ Press u right cursorPlaying a pre-recorded DVD- Video disc Playing a recordable DVD+RW discPoint at which you it stopped the last time by To stop playback at any time, press 9 StopFunctional overview Front of RecorderRF connection to antenna/cable TV signal Back of RecorderOUT Coax coaxial Space free around the ventsDisplay CH Alternate Channel switches to previous TV channel Displays the Timer menuSwitches between different values in a menu Delete last entry/clear a Timer Acknowledge menu selectionOperation Important notes for operationDisc types Loading discsOn-screen display information Discs unsuitable for recording or playingSystem menu bar User preference menu operation Temporary feedback iconsUser preference menu icons Status box Tuner info boxDisc type icons Disc status iconsTimer info box Index Picture Screen Other titleSetting user preferences Picture settingsUser preferences Black level shiftLanguage settings Feature settingsRemote Control settings Record settingsInstallation Update/Re-install TV channelsAdd and delete TV channels VCR Plus+ chTime/Date Automatic ManuallyRecording Before you start recordingManual recording of a TV channel Manual audio control TProessTexitIMER Timer recording with ’VCR Plus+’If a timer recording is incorrect Timer recording without ‘VCR Plus+’Solution Press u right cursor to select ChHow to check or alter a Timer Recording How to clear a timer blockHow to stop a Time Recording in progress Press ClearPlayback Playing a pre-recorded DVD Video discPlaying a Super Video CD To stop play at any time, press 9 StopGeneral features Moving to another title/trackMoving to another chapter/index Slow Motion Still Picture and Frame-by-Frame PlaybackSearch Repeat Repeat A-BScan Time searchSpecial DVD-Video features ZoomMenus on the disc Special VCD features Camera Angle SubtitlesPlayback Control PBC Changing the audio languagePlaying an Audio CD PauseRepeat track/disc Scan Access control Authorizing discs when Child Lock is activatedChild Lock DVD and VCD Activating/deactivating the child lockParental Level DVD-Video only Locking Discs that were formerly UnlockedActivating/Deactivating Parental Control Insert the discCountry Changing the 4-digit codeManaging disc content DVD+RW only Title settingsDisc Information Screen Disc Settings Disc nameProtection Erase discFavorite Scene Selection Edit during playbackInserting Chapter Markers during recording Divide a titleAppend recording Troubleshooting Symptom RemedyTwo languages are ‘mixed’ when recording From a stereo VCR No new title can be recordedDiagnosis program System limitationsInstructions Glossary Term ExplanationVideo TitleTruSurround TV systemEnglish Page Specifications DVD+REWRITABLE Disc FormatPhilips