Philips DVD962SA owner manual You only need one video connection

Hookups (cont’d) 13

Connecting to a TV and a Stereo Receiver

Stereo has Dolby Surround or

Stereo has 2-channel analog (right and left Audio In jacks)

Stereo

(example only)

Back of TV

2 (example only)

3	LEFT AUDIO IN
	RIGHT AUDIO IN	VIDEO IN

	SURROUND CENTER	FRONT
DIGITAL AUDIO OUT		L	1
PCM/MPEG2/Dolby Digital/DTS	L

R	2
R

MAINS

COAXIAL	SURROUND SUB WF FRONT	AUDIO CVBS	Pr/Cr	Pb/Cb	Y	S-VIDEO
	OPTICAL	OUT		VIDEO OUT
	MULTICHANNEL AUDIO OUT

1

PROGRESSIVE SCAN OUT

Pr/Cr Pb/Cb Y

1

Connect one of the yellow CVBS VIDEO OUT jacks of the DVD Player to the corresponding VIDEO IN jack on your TV. Or, use the S-VIDEO or Pr/Cr Pb/Cb Y VIDEO OUT jacks. Details are on pages 10 and

11.You only need one video connection.

2

Connect the supplied red and white audio cables to the red and white Left and Right AUDIO OUT jacks on the DVD Player. Connect the other end of the cables to the left/right AUDIO IN jacks on the Stereo Receiver. Match the cable colors to the jack colors.

3

Connect the DVD Player’s power cord to the MAINS jack on the rear of the DVD Player. Connect the power cords of the DVD Player and the TV to the power outlet. Turn on the power of the TV and the DVD Player.

4

Set the TV to the correct Video In channel. This channel may be near channel 00. See your TV owner’s manual for details. Or, continue to change channels at the TV until you see the DVD Player’s screen saver on the TV screen.

5

Set your Stereo Receiver to the correct Audio In channel or sound source. Refer to the owner’s manual of the Stereo Receiver.