Philips DVP3050V user manual Safety Information

Page 2

H9821MD_DFU_EN1_0214 2/14/05 11:14 AM Page 2

2Safety Information

English

CAUTION

RISK OF ELECTRIC SHOCK

DO NOT OPEN

CAUTION:

TO REDUCE THE RISK OF ELECTRIC SHOCK, DO NOT REMOVE COVER (OR BACK). NO USER SER- VICEABLE PARTS INSIDE. REFER SERVICING TO QUALIFIED SERVICE PERSONNEL.

This “bolt of lightning” indicates uninsulated material within your unit may cause an electrical shock. For the safety of everyone in your household, please do not remove product covering.

The “exclamation point” calls attention to features for which you should read the enclosed literature closely to prevent operating and maintenance problems.

WARNING: TO REDUCE THE RISK OF FIRE OR ELECTRIC SHOCK,THIS APPARATUS SHOULD NOT BE EXPOSED TO RAIN OR MOISTURE,AND OBJECTS FILLED WITH LIQUIDS, SUCH AS VASES, SHOULD NOT BE PLACED ON THIS APPARATUS.

CAUTION: To prevent electric shock, match wide blade of plug to wide slot, fully insert.

Safety Precautions

Warning: To prevent fire or shock hazard, do not expose this equipment to rain or moisture.

Federal Communications Commission (FCC) Warning: Any unauthorized changes or modifications to this equipment void the user’s authority to operate it.

Do not stand the unit up vertically. Install the unit in a horizontal and stable position.

Be sure to remove the disc and unplug the AC power cord from the output before carrying the unit.

Department of Health and Human Services (DHHS) Certification: Complies with 21 Center for Radiation (CFR) chapter 1 subchapter J applicable at time of manufacture.

Laser Safety: This unit employs a laser. Only a qualified service person should remove the cover or attempt to service this device, due to possible eye injury.

CAUTION: USE OF CONTROLS OR ADJUSTMENTS OR PERFORMANCE OF PROCEDURES OTHER THAN THOSE SPECIFIED HEREIN MAY RESULT IN HAZARDOUS RADIATION EXPOSURE.

CAUTION:VISIBLE AND INVISIBLE LASER RADIATION WHEN OPEN AND INTERLOCK DEFEATED. DO NOT STARE INTO BEAM.THE BEAM IS LOCATED INSIDE, NEAR THE DECK MECHANISM.

Special Information for Canadian Users: This Class B digital apparatus complies with Canadian ICES-003. Cet appareil numérique de la classe B est conforme à la norme

NMB-003 du Canada.

Radio/TV Interference: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules.These limits are designed to provide reasonable protection against harmful interference in a residential installation.This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

1) Reorient or relocate the receiving antenna.

2)Increase the separation between the equipment and the receiver.

3)Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.

4)Consult the dealer or an experienced radio/TV technician for help.

Copyright Protection: Unauthorized copying, broadcasting, public performance, and lending of Discs are prohibited.

This product incorporates copyright protection technology that is protected by U.S. patents and other intellectual property rights. Use of this copyright protection technology must be authorized by Macrovision, and is intended for home and other limited viewing uses only unless otherwise authorized by Macrovision. Reverse engineering or disassembly is prohibited.

Notice for Progressive Scan Use: Consumers should note that not all high definition television sets are fully compatible with this product and may cause artifacts to be displayed in the picture. In case of picture problems with 525 and 625 progressive scan output, it is recommended that the user switch the connection to the ‘standard definition’ output. If there are questions regarding your TV set compatibility with this 525p and 625p DVD player, please contact our customer service center.

Note to the Cable TV System Installer: This reminder is provided to call the Cable TV system installer’s attention to Article 820-40 of the National Electrical Code, which provides guidelines for proper grounding – in particular, specifying that the cable ground shall be connected to the grounding system of the building, as close to the point of cable entry as possible.

Manufactured under license from Dolby Laboratories. "Dolby" and the double-D symbol are trademarks of Dolby Laboratories. Copyright 2005 Philips. All rights reserved.

Image 2
Contents Need help fast? Safety Information Table of Contents Introduction Playable Discs and Video Cassettes Hookups Determining the best possible connectionHookups cont’d Connections RememberRF coaxial cable TV’s Antenna SignalCable Composite, or Baseband video Jack of your DVD/VCRDVD/VCR Audio OUT jacks on the DVD/VCR and to the red Video OUT jacks on the DVD/VCR and to the ComponentDVD/VCR to a TV and a Stereo Check your Stereo manual for detailsStereo Recycling Guidelines/Battery Safety Putting Batteries in the Remote ControlUsing the Remote Control First-time DVD/VCR Setup Read and follow the steps below to play a tape Other tape playback features are on pagesVideo Cassette Playback Turn on the TV Insert a tape in the DVD/VCROn the DVD/VCR Disc PlaybackPress OPEN/CLOSE a Insert a DiscVCR Display Panel Display PanelDVD Display Panel Display MessagesFront Panel Front Panel, Rear Panel, and Remote ControlRemote Control Rear PanelChannel Setup Adding/Deleting ChannelsWhile the DAY space is flashing, press K or L until Press CLEAR/RESET or B to start the clockClock VCR While the Year space is flashing, press K or LVCR Status Displays Press CLEAR/RESET to remove the menuLanguage VCR Press Display again to remove all the displaysTo stop recording, press Stop C Videotape RecordingRecording Prevention Press VCR/TV on the DVD/VCR remote control to Use the TV remote control to select the channelRemote control to return to channel 03 or 04 at Press VCR, then press Record I to recordStopping an OTR When an OTR endsOne-Touch Recording Or SkipMake the connections shown above Point the remote control at DVD/VCR 2. PressRerecording Tape Duplication Turn on the TV and set it to channel 03 or 04Timer Recording Instructions continue onWhen a timer recording ends Timer Recording cont’dCancelling Timer Recordings Will flash. Insert a tapeDVD to Videotape Duplication Speed are onRepeat Playback Tape CounterIndex Search Time Search, Index SearchTime Search A recording by following these stepsAutomatic Operation Features Special Effects PlaybackMulti-Channel Television Sound Multi-Channel Television Sound / Hi-Fi StereoUnderstanding Displays Hi-Fi StereoPlayback Control PBC Function Using the Title MenuMenus, Playback Control PBC Function Press K, L, s, or B to select an item, then pressDuring playback, press Search g or h on Remote controlFast Forward/Reverse Search Press Play B to return to normal playbackTime Playback Title/Chapter Playback,Time PlaybackTitle/Chapter Playback Playback will start at the selected Track Using SearchTrack Playback Within 30 seconds of the previous numberDuring Disc Playback, press Pause F. Playback will Paused and Step-by-Step PlaybackResume On Press Play B to resume playRepeat Repeat Playback, A-B RepeatRepeat Playback Let you start over OFF will appear briefly onTo return to a Marker during playback, press MarkersWithin 30 seconds, press s or B to select a Marker Camera Angles Subtitles, Camera AnglesSubtitles During playback, press Subtitle repeatedly toAudio Language Audio Language, Stereo Sound ModeStereo Sound Mode During DVD playback, press Audio repeatedly toZoom Slow Motion, ZoomSlow Motion Press Pause F during DVD or Video CD playbackRandom Playback Program/Random PlaybackProgram Playback 44 MP3/Windows MediaTM Audio/JPEG Playback File List will appear Dual PlaybackFolder Playback Audio CD and Video CD Displays On-Screen DisplaysDVD Displays Displays during DVD playbackOn-Screen Displays cont’d Press Display again to remove the displayBlack Level Black Level,Virtual SurroundInitializing Virtual SurroundInstructions continue on the next Press K or L to select a language, then press Language cont’dLanguage Codes Press s or B to select Custom at the top Select a setting, then press OKDisplay If you selected TV ASPECT, press K or L toProgressive Scan You may adjust the Progressive Scan compatibilityDisplay cont’d Instructions from previousDVD Player of the DVD/VCR Press DVD to put the DVD/VCR in DVD modeAudio While playback is stopped, pressPress sor B to select Parental LevelsPress sor B to select Custom at the top Menu, then press OK PARENTAL, at the topPress OK, and proceed to step Press L to select Password CHANGE, then pressWhile playback is stopped, press SYSTEM/MENU Press the Number buttons to enter your currentOthers Press s or B to select OTHERS, then Press OKOthers cont’d Press SYSTEM/MENU to remove the menusGlossary Cable Box/Satellite Receiver Output Channel 03 orHelpful Hints Helpful Hints cont’d You cannot insert a video cassette Line Input modeCleaning the Video Heads You cannot remove the tapeCare and Maintenance SpecificationsMemo Memo Information Index Controls Dvd/vcr