H9821MD_DFU_EN1_0214 2/14/05 11:14 AM Page 8
English
8Hookups (cont’d)
DVD/VCR to Cable Box or Satellite Receiver and TV
Using only basic RF coaxial cables
This connection will let you use the features of both the VCR and the DVD Player.
1Cable Box/Satellite Receiver |
|
|
|
| 2DVD/VCR | ||
|
|
|
|
|
|
| 75 |
| IN |
|
|
|
|
| ANT / |
|
|
|
|
|
| CABLE | |
| OUT |
|
|
|
|
| |
|
|
|
|
|
|
| |
|
| DVD |
|
| DVD/VCR | VCR |
|
| DIGITAL | AUDIO | COMPONENT | AUDIO OUT AUDIO IN |
| ||
| VIDEO OUT | ANT - IN | |||||
| AUDIO OUT | OUT | OUT | CB / |
|
| |
|
| L |
| L | L | RF coaxial cable | |
Cable |
|
|
| Y |
| ||
| R |
| CR / | R | R | ||
| COAXIAL |
|
| PB |
| ||
|
|
|
| VIDEO OUT VIDEO IN |
| ||
Signal | PR |
|
RF coaxial cable | 3 | TV’s ANTENNA |
| IN Jack | |
|
|
Connections
1 Connect a Cable TV or Satellite signal to the IN jack on the Cable Box/Satellite Receiver.
2 Use an RF coaxial cable (as the one supplied) to connect the OUT jack on the Cable Box/Satellite Receiver to the
3 Use a second RF coaxial cable to connect the
4 Plug in the power cord of your TV.Turn on the TV and set it to channel 3 or 4.
5 Plug in the power cord of the DVD/VCR.You are ready to turn on the DVD/VCR. Go to page 14 before turning it on.
Remember...
There are two ways to connect your Cable Box/Satellite Receiver to the DVD/VCR.With the connection on this page:
●Select TV channels at the Cable Box/Satellite Receiver, not the DVD/VCR.To record or view TV channels, follow these steps:
1)Press VCR to put the DVD/VCR in VCR mode.VCR light will appear on the front of the DVD/VCR.
2)Press SKIP ∑/CH o or SKIP w/CH p to set the DVD/VCR to the Cable Box/Satellite Receiver output channel (03 or 04).
3)Set the TV to the DVD/VCR’s output channel (03 or 04).The DVD/VCR’s output channel is channel 3 when the DVD/VCR is new.To change it from 3 to 4, press and hold
(VCR) PLAY B on the DVD/VCR for
4)Select the channel you want to view/record at the Cable Box/Satellite Receiver.
●You may not view a channel other than the one you are recording.
●You can only program a timer recording for one channel at a time. Set your Cable Box/Satellite Receiver to the channel you want to record.When you enter the channel you want to record in a timer recording, select channel 03 or 04 (the Cable Box/Satellite Receiver output channel). (This is step 8 on page 26.) Leave the Cable Box/Satellite Receiver on for a timer recording.
Helpful Hint
•If your Cable Box or Satellite Receiver has Audio and Video Out jacks, use audio and video cables to connect them to the VCR AUDIO IN and VIDEO IN jacks on the rear of the DVD/VCR.You will not need the RF coaxial cable connection between the Cable Box/Satellite Receiver and the DVD/VCR as described at step 2.