Philips DVP630, DVP632 manual Connecting the power cord, Using an accessory RF modulator

Connections
							Connecting the power cord
	RF coaxial cable to TV
		2
				Back of RF Modulator
					(example only)
	INT IN		TO TV	VIDEO	AUDIO IN
				IN	R	L
						CH3	CH4
									COMPONENT
								S-VIDEO	VIDEO IN
							AUDIO	IN	V (Pr/Cr)
							OUT
									~ AC MAINS
									U (Pb/Cb)
								VIDEO IN
									Y
Antenna or
Cable TV signal						1
										VIDEO
									L	OUT
		VIDEO	Pb	Pr
L		OUT
									R
R			Y							S
							RGB		AUDIO OUT
					COAXIAL OPTICAL
AUDIO OUT		S-VIDEO
			OUT		DIGITAL OUT

IMPORTANT!

–If your TV only has a single Antenna In jack (or labeled as 75 ohm or RF In,) you will need an RF modulator in order to view the DVD playback on the TV. See your electronics retailer or contact Philips for details on RF modulator availability and operations.

Using an accessory RF modulator

1Use the composite video cable (yellow) to connect the DVD Player’s CVBS jack to the video input jack on the RF modulator.

2Use the RF coaxial cable (not supplied) to connect the RF modulator to your TV’s RF jack.

After everything is connected properly, plug in the AC power cord to the power outlet.

Never make or change any connections with the power switched on.

When no disc is loaded, press

STANDBY ON on the DVD Player front panel,

“NO DISC” may appear on the display panel.

OPEN/CLOSE NO DISC STOP PLAY/PAUSE

9

01-36 DVP630_EU_051 9 18/03/2004,/0510:04_8239AM 210 98393