Basic Connections (continued)
Clean Cloth
A
C
B
To lock stand, slide to left
Step 2: Placing the unit
Before you start....
–Make sure that all cables have been connected to this unit.
–To prevent this unit from being scratched, always covers its front surface with a cloth before you place it flat on any surface.
Option 1: Placing on the table top
A Place this unit on a flat surface with the front panel facing down.
B Place the detachable stand on the rear panel.
C Slide the stand to the left to lock it into position.
A | B | English |
C
Option 2: Mounting on the wall
CAUTION!
Risk of personal injury and damage to the unit. Allow only qualified persons to mount the unit.
Note:
Mounting accessories not supplied.
A Mark the wall for screw hole positions where you intend to mount this unit, then drill the screw holes.
B Insert the rubber wall plugs and screws into the holes.
C Hook this unit firmly onto the screws and lock into position.
Helpful Hint:
–To remove the stand, press and hold the catch at the extreme right of the rear panel and push the panel towards the right.
15
1dvp6620_eu_eng.indd 15 |