Philips MCD170/98 user manual Get started, Prepare the remote control, Auto install radio stations

Page 13

4 Get started

Caution

•Use the controls only as stated in this user manual.

Note

•Before pressing any function button on the remote control, ﬁrst select the correct source with the remote control instead of the main unit.

•If you are not going to use the remote control for a long time, remove the battery.

Always follow the instructions in this chapter in sequence.

If you contact Philips, you will be asked for the model and serial number of your DVD Micro Theater.The model number and serial number are on the rear of your DVD Micro Theater.

Write the numbers here:

Model No. __________________________

Serial No. ___________________________

Prepare the remote control

Caution

•Risk of explosion! Keep batteries away from heat, sunshine or ﬁre. Never discard batteries in ﬁre.

For ﬁrst-time use:

1 Remove the protective tab to activate the remote control battery.

To replace the remote control battery:

1 Open the battery compartment.

2 Insert 1 CR2025 battery with correct polarity (+/-) as indicated.

3 Close the battery compartment.

Auto install radio stations

When you connect the DVD Micro Theater to the power supply for the ﬁrst time, or no radio station is stored in this DVD Micro Theater, Plug and Play is activated to store all available radio stations automatically.

1 Connect the DVD Micro Theater to the power supply.

2 Press on the main unit to start installation.

»[AUTO] (auto) is displayed.

»The DVD Micro Theater automatically store radio stations with sufﬁcient signal strength.

»When all the available radio stations are stored, the ﬁrst preset radio station is broadcast automatically.

14EN

Image 13

Contents Register your product and get support at MCD170/98 ZH-TW 使用手冊Contents Safety Know these safety symbols Hearing safetyListen at a moderate volume Environmental information Be careful not to adjust the volume as your hearing adaptsThis DVD Micro Theater includes this label What’s in the box IntroductionYou can play DVDs with the following region code Asia Paciﬁc, Taiwan, Korea Australia, New ZealandOverview of the main unit Overview of the remote Control Zoom in or out a picture/video image on the TV screen Preparations ConnectConnect speakers Connect audio cablesConnect video cables Connect the MW antenna Connect powerOption 3 connect component video cables Connect the supplied MW antenna to the MW Aerial socketAuto install radio stations Prepare the remote controlGet started Always follow the instructions in this chapter in sequenceSwitch to standby Set up the TVSet clock Turn onPlay discs PlayPlay DivX video Play from USB devicesView pictures Play tapePlay options Play controlReview program ProgramChange camera angle Select an audio languageListen to radio Select a preset radio stationTune to a radio station Program radio stations manuallyAuto record from CD to tape RecordRecord a section of a disc to tape Record from radio to tapeAdjust volume level Adjust soundSelect a preset sound effect Enhance bassSystem settings Adjust settingsPlayback settings Restrict DVD play Select TV systemChange parental control password Video settingsSelect video signal View DivX VOD registration codeAdjust picture quality Audio settingsSelect reverb mode Select digital outputNight Mode Enable night modeSelect sampling rate Set the alarm timer Other featuresSet the sleep timer Activate and deactivate alarm timerSpeciﬁcations Product informationSupported MP3 disc formats USB playability informationGeneral information Remote control does not work TroubleshootingReplace or clean the disc Multi-language sound or subtitle is not recorded on the DVDPoor radio reception Cannot display some ﬁles in USB deviceJpeg GlossaryMP3 Parental control MultichannelPBC PCM