Tuner Operations
English
IMPORTANT!
Make sure the FM and MW antennas are connected.
Tuning to radio stations
A Press SOURCE repeatedly until “FM” appears on the display panel (or press TUNER on the remote control).
B Press S / T briefly on the remote control to start tuning.
“SEARCH > or <” will appear on the display panel until a radio station with sufficient signal strength is found.
C Repeat step B if necessary until you find the desired radio station.
D To
Presetting radio stations
You can store up to 40 FM and 20 MW preset radio stations in the memory. There are three different ways to programme the radio stations:
–Using auto install (for first time setup only)
–Using automatic preset
–Using manual preset
Helpful Hints:
–The system will exit presetting mode if no button is pressed within 20 seconds.
–If no stereo signal is detected or less than
5 (fi ve) stations are detected during tuner installation, “PLEASE CHECK ANTENNA” appears.
Using auto install
This feature is only applicable for first time radio station programming. You will be prompted to install the radio stations when you access the tuner mode. With one touch of button, all the available radio stations will be stored automatically.
display panel
A Press TUNER.
“AUTO INSTALL PRESS PLAY” appears.
B Press PLAY X until “START ...” appears on the display panel.
The system will start searching from the FM band followed by the MW band.
All the available radio stations with
strong signal will be stored automatically. Once complete, the last tuned radio
station will be played back.
40