Play from USB device
This Home Theater System plays/views MP3, WMA, DivX (Ultra) or JPEG files on the following USB devices:
•flash drive
•memory card reader
•HDD (external power source needed)
/
1 Connect a USB storage device to the
(USB) jack.
2 Press USB.
»A contents menu is displayed.
3 Select a file to play, then press
.
»Play starts.
4 To stop play, press 
or remove the USB device.
Note
•If the device does not fit into the USB jack, connect it through a USB extension cable.
•If you connect a multiple USB card/device reader, only one card/device can be accessed.
•Digital cameras that need PC software or use
PTP protocol are not supported.
Play from radio
Check if the FM antenna has been connected | English |
to this Home Theater System. If not, connect |
|
the supplied FM antenna to the FM75 jack |
|
and fix its ends to the wall. | Play |
| |
FM |
|
(75 Ω) |
|
ANTENNA |
|
Tip
•For better FM stereo reception, connect an external FM antenna (not supplied).
•Position the antenna as far away as possible from your TV, VCR or other radiation source to prevent interference.
First time tuning
When you access to radio mode for the first time, follow the instructions to install the radio stations.
1 Press RADIO.
»’AUTO INSTALL ... PRESS PLAY’ is displayed.
2 Press 
.
»All detected radio stations are stored.
»Once complete, it tunes to the first preset radio station.
• To stop auto tuning, press 
.
Note
•This Home Theater System can store up to a maximum of 40 radio stations.
•If auto installation is not activated or less than 5 radio stations are stored, you will be prompted to install the radio stations again.
EN 23