Basic Operations
IMPORTANT!
–Before you operate the system, complete the connection procedures.
–When the system is switched to Standby mode, it is still consuming power.To disconnect the system from the power supply completely, reomve the AC power plug from the wall socket.
Plug and Play (for tuner installlation)
Plug and Play allows you to store all available radio stations automatically.
First time setup/power up
1When you turn on the main supply, "AUTO INSTALL - PRESS PLAY " is displayed.
2Press ÉÅ on the system to start installation.
➜ "PLUG AND PLAY" .... "INSTALL" is
displayed, followed by "TUNER" and "AUTO".
➜PROG starts flashing.
➜The system will automatically store the radio stations (FM only ) with sufficient signal strength.
➜When all the available radio stations are stored or the memory for 20 presets are used, the last preset radio station will be played.
To reinstall Plug and Play
1In standby mode, press and holdÉÅ on the system until "AUTO INSTALL - PRESS PLAY" is displayed.
2Press ÉÅ again to start installation.
➜ All previously stored radio stations will be replaced.
To exit without storing the Plug and Play
●Press 9 on the system.
➜ If you do not complete the Plug and Play installation, the function will be restarted when you next turn on the main supply again.
Notes:
–If no stereo frequency is detected during Plug and Play, "CHECK ANTENNA" will be displayed.
Switching the system on/off
●In
➜ The system will switch to the selected or last selected source.
To switch the system to standby mode
●In
➜ The clock time will be displayed. Or
To switch the system to Eco-power standby mode
●In
➜“ECO POWER” is displayed briefly.
➜
➜The LCD display will go blank.
Helpful hints:
–Pressing and holding B on the remote can switch between
Power saving automatic standby
As a
English
19