Basic Operations

IMPORTANT!

–Before you operate the system, complete the connection procedures.

–When the system is switched to Standby mode, it is still consuming power.To disconnect the system from the power supply completely, reomve the AC power plug from the wall socket.

Plug and Play (for tuner installlation)

Plug and Play allows you to store all available radio stations automatically.

First time setup/power up

1When you turn on the main supply, "AUTO INSTALL - PRESS PLAY " is displayed.

2Press ÉÅ on the system to start installation.

➜ "PLUG AND PLAY" .... "INSTALL" is

displayed, followed by "TUNER" and "AUTO".

➜PROG starts flashing.

➜The system will automatically store the radio stations (FM only ) with sufficient signal strength.

➜When all the available radio stations are stored or the memory for 20 presets are used, the last preset radio station will be played.

To reinstall Plug and Play

1In standby mode, press and holdÉÅ on the system until "AUTO INSTALL - PRESS PLAY" is displayed.

2Press ÉÅ again to start installation.

➜ All previously stored radio stations will be replaced.

To exit without storing the Plug and Play

●Press 9 on the system.

➜ If you do not complete the Plug and Play installation, the function will be restarted when you next turn on the main supply again.

Notes:

–If no stereo frequency is detected during Plug and Play, "CHECK ANTENNA" will be displayed.

Switching the system on/off

●In standby/Eco-power standby mode, press STANDBY-ONBor SOURCE on the set, or DISC, USB, FM or AUX on the remote to switch on the system.

➜ The system will switch to the selected or last selected source.

To switch the system to standby mode

●In power-on mode, press briefly STANDBY- ONB (B on the remote).

➜ The clock time will be displayed. Or "--:--" will be displayed if clock time is not set.

To switch the system to Eco-power standby mode

●In power-on mode, press and hold STANDBY- ONB (B on the remote).

➜“ECO POWER” is displayed briefly.

➜Eco-power lamp B on the front panel will light up.

➜The LCD display will go blank.

Helpful hints:

–Pressing and holding B on the remote can switch between Eco-power standby and normal standby.

Power saving automatic standby

As a power-saving feature, the system will automatically switch to Standby mode if you don’t press any button within 15 minutes in the stop mode.

English