STANDBY/ON
VIDEO
LASER INDICATOR
RGB
SCS
LENS SHIFT
+
–––
++
FOCUSZOOM
STANDBY/ON
VIDEO
LASER INDICATOR
RGB
BLANKASPECT LASER
LENS SHIFT
+
–––
++
FOCUSZOOM
15

Turning On The Power

WARNING • When the power is ON, a strong light is emitted. Do not look
into the lens or vents of the projector.
• Turn the power on/off in right order. Please power on the projector before
the connected devices. Power off the projector after the connected devices.
NOTE
Power ON/OFFPower ON/OFF
Remove the lens cap.
2
Set the power switch to [ | ] (ON).
The standby/on indicator will light to solid orange.
standby/on
standby/on button / indicator
LENS SHIFT
buttons
Power switch (ON position)
STANDBY/ON
button
STANDBY/ON
3Press the STANDBY/ON button.
The projector lamp will light up and the
standby/on indicator will begin blinking green.
When the power is completely on, the indicator
will stop blinking and light green.
4Use the LENS SHIFT buttons to shift the
picture upward or downward. (X80 only)
memo
X70 does not have the lens shift function.
X70 has the volume buttons instead of the lens
shift buttons on the projector.
5Select an input signal according to the
section “Selecting An Input Signal” of the
following page.
lens shift
Power switch (OFF position)
1
Press the STANDBY/ON button.
The message “Power off?” will appear on
the screen for approximately 5 seconds.
Attached the lens cap.
2
Press the STANDBY/ON button again while
“Power off?” the message is visible.
The projector lamp will go off, and the standby/on
indicator will begin blanking orange.
Then the standby/on indicator will stop blinking and
light to solid orange when the lamp cooling is
complete.
3Switch the power switch to [O] (OFF).
The standby/on indicator will go off.
STANDBY/ON
button
STANDBY/ON
standby/on
standby/on button / indicator

Turning Off The Power

STANDBY/ON
VIDEO
LASER INDICATOR
RGB
BLANKASPECT LASER
LENS SHIFT
+
–––
++
FOCUSZOOM
1
4
X80