38
Lamp (continued)Lamp (continued)
After making sure that the projector has cooled
adequately, slide the knob of a lamp door lock as
shown in the Figure.Then, one side of the lamp door
is raised. Pull up the lamp door and remove it, as
shown in the Figure.
If the indicators or a message prompts you to replace the lamp, replace the lamp as soon
as possible.
Turn off the projector, and unplug the power cord. Allow the lamp bulb to cool for at
least 45 minutes.
2
1
Contact your dealer to prepare a new lamp. Tell the dealer your lamp type number.
If the projector is mounted on the ceiling, or if the lamp has broken, also ask the
dealer to replace the lamp.
3
4Unscrew the 3 screws, and slowly pull out the lamp
by the handle. Be careful not to touch the inside of
the lamp case.
5Insert the new lamp, and tighten the 3 screws firmly
to lock it in place.
6Interlocking the 2 tabs of the lamp door to the
projector, put the lamp door on the projector. Then
push the point of the lamp door to fix it, as shown in
the Figure. Make sure that the lamp door doesnt
come up.
7Turn on the projector, and reset the lamp timer.
(1) While the projector running, press the MENU button to open the menu.
(2) Choose the OPTION on the menu using the /button, then press the
button or ENTER button.
(3) Choose the LAMP TIME using the /button, then press and hold the
RESET button for 3 seconds.
(4) Choose the RESET using the button.
memoWhen the lamp has been replaced after the message of "THE POWER WILL
TURN OFF AFTER 0hr." is displayed, complete this operation within 10 minutes of
switching power on.
memoIncorrectly resetting of the lamp timer (resetting without replacement, or
neglect of resetting after replacement) will result in incorrect message functions.
Lamp door
Lamp door
knob
Tabs

In the case of replacement by yourself,

Screws
CO LAMP
PC

Replacing The Lamp

Do not use the projector with the lamp door removed. At the lamp replacing, make
sure that the screws are screwed in firmly. Loose screws could result in damage or injury.
NOTE