Philips MCD908/37 owner manual Connecting speakers, Connecting the control cable, Connecting TV

Connections

English

Step 2: Connecting speakers

●Connect the left and right speakers to the SPEAKERS (4Ω) terminals on the back of the power amplifier with the supplied speaker cables. Right speaker to “R” and left speaker to “L”, red wire to “+” and black wire to “-”. Fully insert the stripped portion of the speaker wire into the terminal as shown.

2

1 3

Speaker wire connection on main set

Step 3: Connecting the control cable

●Connect the serial port marked “CONTROL CABLE” at the rear of the DVD player to the same port at the rear of the power amplifier with the supplied flat control cable.

Step 4: Connecting TV

IMPORTANT!

–You only need to make one video

connection from the following options, depending on the capabilities of your TV.

–Connect the DVD system directly to the TV.

Using Composite Video jack

1 2

Speaker wire connection on speakers

Notes:

–Ensure that the speaker cables are correctly connected. Improper connections may damage the system due to short-circuit.

–For optimal sound performance, use the supplied speakers.

–Do not connect more than one speaker to any one pair of +/- speaker jacks.

–Do not connect speakers with an impedance lower than the speakers supplied. Please refer to the SPECIFICATIONS section of this manual.

1Use the composite video connectors (yellow) of the supplied audio and composite video cables (2-in1) to connect the DVD system's VIDEO OUT jack to the video input jack (or labeled as A/ V In, CVBS, Composite or Baseband) on the TV.

2To hear the TV channels through this DVD system, use the audio connectors (white/ red) of the supplied audio and composite video cables (2-in1) to connect AUX IN L/R jacks to the corresponding AUDIO OUT jacks on the TV.

12