Philips MCD908/37 owner manual Component, TV Mode, Quality

System Menu Options

English

COMPONENT

Sets the video output according to your video connection.This setting is not required if you are using the VIDEO jack (yellow) to connect the DVD micro system to your TV.

➜S-VIDEO: Select this if you have connected the DVD micro system to your TV using S-Video jack.

➜Pr/Cr Pb/CbY: Select this if you have connected the DVD micro system to your TV using Component video jacks.

NoteS:

–When the player is set to Y Pb Pr (YUV), some TV may not properly synchronise with the player on the SCART connector.

–This option is available only when the "HDMI" is set to "OFF".

TV MODE

Selects interlace or P-SCAN video output mode when Pr/Cr Pb/CbY is selected.

➜P-SCAN and INTERLACE.

In the progressive scan mode, you can enjoy the high quality picture with less flickers. It only works when you have connected the DVD player's Y Pb Pr jacks to your TV that supports the progressive video input. Otherwise, a distorted picture will appear on the TV. For proper progressive scan set up, see “Getting started-Setting up Progressive Scan feature”.

Note:

–This option is available only when the "HDMI" is set to "OFF".

QUALITY

This menu helps you to set the video quality.

1Press 3 4 to highlight “QUALITY”.

2Press 2 or OK to enter Quality Setup.

The options included in Quality Setup page are: “SHARPNESS”,“BRIGHTNESS”, “CONTRAST”, “GAMMA”, “HUE”, “SATURATION” and “LUMA DELAY”.

SHARPNESS

Adjusts the sharpness level.

➜HIGH, MEDIUM and LOW.

BRIGHTNESS

Adjusts the brightness level. Range: -20-+20.

CONTRAST

Adjusts the contrast level. Range: -16-+16.

GAMMA

Adjusts the gamma level.

➜HIGH, MEDIUM, LOW and NONE.

HUE

Adjusts the hue level. Range: -9-+9.

SATURATION

Adjusts the saturation level. Range: -9-+9.

LUMA DELAY

Adjusts the luma delay.

➜0 T and 1 T.

34