Philips MDV450 owner manual Video Output,Video Mode, Component Video In jacks as described on

MDV450 25/09/2002 9:46 AM Page 34

34 Video Output,Video Mode

Video Output

If you used S-Video or Component video connections as described on pages

11-12, set the VIDEO OUTPUT to S-VIDEO to YCBCR (for Component Video) by following the steps below.You only need one video connection between the TV and the DVD Player.You can not use S-Video and Component Video at the same time.

If you used the yellow VIDEO (VIDEO OUT) jack on the Player to connect the Player to the TV, you do not need to adjust the VIDEO OUTPUT setting.

1 Press SYSTEM MENU.

2 Press 4 repeatedly to select SETUP VIDEO OUTPUT, then press OK.

3 Press 4 to select VIDEO OUTPUT, then press 2.

Press 3 or 4 to select S-VIDEO or YCBCR, then press OK.
Choose S-VIDEO if you connected the Player’s S-VIDEO (VIDEO OUT)
4 jack to the TV’s S-Video In jack as described on page 11. Choose YCBCR if
you connected the Player’s YCBCR (VIDEO OUT) jacks to your TV’s
Component Video In jacks as described on page 12.
- - VIDEO OUTPUT PAGE - -
TV DISPLAY
VIDEO OUTPUT F	S-VIDEO
TV TYPE	YCBCR
VIDEO MODE
BRIGHTNESS
CONTRAST
SATURATION

VIDEO OUTPUT YCBCR

5 Press SYSTEM MENU to remove the menus.

Video Mode

Just as you can adjust your picture on your TV, you can adjust some picture elements at the DVD Player. Choose a picture setting that best displays the Disc you are playing.This feature is known as Smart Picture or Video Mode and can be adjusted by following the steps below.

1 Press SYSTEM MENU.

2 Press 4 repeatedly to select SETUP VIDEO OUTPUT, then press OK.

3 Press 4 repeatedly to select VIDEO MODE, then press 2.

Press 3 or 4 to select BRIGHT, STANDARD, SOFT, or
4 PERSONAL, then press OK.
- - VIDEO OUTPUT PAGE - -
TV DISPLAY
VIDEO OUTPUT
TV TYPE
VIDEO MODE	F BRIGHT
BRIGHTNESS	STANDARD
CONTRAST	SOFT
SATURATION	PERSONAL

1,5

2-4

1

2-4

SET STANDARD VIDEO OUTPUT