Getting Started
Step 1: Preparing the remote control
Before you start using the remote control, pull out the plastic protective sheet.
To change the battery
●Pull out the battery compartment and replace with the battery type LITHIUM CR2025.
Using the remote control to operate the system
1Aim the remote control directly at the remote sensor (iR) on the front panel.
2Press SOURCE button on the remote to select the mode you wish to control (for example TV, DISC). The selected source mode will light up on the LED panel for a few seconds.
3Then select the desired function (for example É, S, T).
E n g l i s h
CAUTION!
–Remove battery if it is exhausted or if the remote control is not to be used for a long time.
–Batteries contain hazardous chemical substances, so they should be disposed of properly.
Step 2: Switching on the DVD system
●Press SOURCE button repeatedly to select :
DISC ™ TUNER FM ™ TV ™ AUX
™DI ™ DISC ....
Switching to Eco Power standby mode
●Press STANDBY ON (B).
➜The display screen will go blank.
➜The Eco Power indicator will light up in red.
19
19 | 22/04/2005, 04:05 PM | |
|
| 3139 115 2xxx1 |