Instructions for use
English
-5 Enter your
–The green LED flashes twice.
C h e c k
That’s it! Press a few keys to check correct response. If response is not correct, repeat procedure beginning at step 1.
N o t e
-If the LED displays one long flash, the code was not recognised. Please go back to step 1 and repeat the procedure, using the next
-If no key is pressed within 30 seconds, you have to start again at step 1.
A d v i c e
Carefully read the complete procedure before starting!
You do not know the brand of your equipment/you can not find the right code in the code list » auto search:
1 Press the mode selector key for the device (TV or VCR) you want to operate.
2 Make sure the device is switched on (if the device is a VCR, please insert a tape and start playback).
3 Press and hold keys 1 and 3 simultaneously
4 Press the power key to start the search. Make sure that you keep the remote control pointed at your equipment.
–Each time the green LED flashes, another code is sent. When the right code is found, the equipment switches off. Immediately press the power key to stop the search.
If the green LED flashed again after the equipment switched off, this means you missed the correct code! If you missed the code, follow the next proccedure, starting at step 5. If the LED did not flash again after the equipment switched off, go to step 7.
5 Switch the equipment manually back on.
6 Press ‘P’ (down only!) repeatedly to send previous codes until the equipment switches off again.
7 Press the power key to lock the correct code in the SBC RU220’s memory.
–The green LED flashes twice.
C h e c k
Switch equipment on manually. Press a few keys to check correct response. If response is not correct, repeat procedure beginning at step 1.
4