English
Instructions for use
TROUBLESHOOTING GUIDE
•Problem:
– Solution:
•Device is not responding and the green light does not flash when you press a button.
–Replace batteries with two new 1.5 volt, type RO3, UM4 or AAA batteries.
•Device is not responding, but the green light does flash when you press a button.
–Aim the SBC RU220 at the device and be sure that there are no obstructions between the SBC RU220 and the device.
• The SBC RU220 is not performing commands properly.
–You may be using the wrong code. Try repeating Set up using another code, listed under your brand, or start the Autosearch
If the device still doesn’t respond, call the
•Having problems operating all the functions on your device.
– The SBC RU220 may just need customising for your model type. Just call our
•Your brand is not listed in the code list.
– Try the hands-free Autosearch method.
•You want to reset the remote control to its factory preset.
– 1 Press and hold keys 1 and 6 simultaneously - for about 3 seconds - until the green LED lights up.
– 2 On the keypad, press keys 9, 8, and 1.
The LED flashes twice to indicate a successful reset.
NEED HELP?
If you have any questions about the SBC RU220, please call our
Before you call, please read this manual carefully. You will be able to solve most of your problems. If you don’t find an answer to your questions, make a note of your equipment in the table at the back of the code list section of this booklet. This makes it easier and faster for our operators to help you. Look for the model numbers in the equipment instruction manual, or on the back of your equipment. When calling our
6