Checking The Auto Scan Codes, Set, Blink twice

PROGRAMMING YOUR REMOTE CONTROL (continued)

Checking The Auto Scan Codes

If you have set up the remote control using Auto Scan,you can now find out which four- digit code is operating your component:

1.	On the remote con-
	trol, press a compo-
	nent key once (e.g.,
	TV, VCR, CBL, AUD, DSS, or CD).
2.	Press and hold SET until the red
	light blinks twice, then release
	SET.
3.	Enter 9-9-0. The red light will
	blink twice.
4.	To view the code for the first
	digit, press 1 once. Wait 3 sec-
	onds, count the red light blinks
	(e.g., 3 blinks = 3) and write
	down the number.
	NOTE: If a code digit is “0”, the
	red light will not blink.
5.	Repeat step 4 three more times
	for remaining digits. Use 2 for
	the second digit, 3 for the third
	digit, and 4 for the fourth digit.

6.To find codes of other compo- nents, repeat steps 1 through 5, but substitute the appropriate key (e.g., VCR, CBL, AUD, DSS, or CD) for the component you are checking. As before, write down each four-digit code.

Re-Assigning Component Keys

The DSS remote can be set up to control any combination of six home entertainment components.By following these instructions, you can re-assign or duplicate a component key onto an unused component key.

1. Press and hold SET until the red light blinks twice, then release SET.

2. Enter 9-9-2. The red light will blink twice.

3.Press the Component key (e.g., TV, VCR, etc.) to be moved once, then press the Component key (e.g.,AUD, etc.) to be re-assigned once. When re-assignment is done, the red light will blink twice to confirm your choice.

4.The re-assigned key is now ready to be programmed for the new component. See Programming Other Components on page 5.

Example – Re-assigning The AUD Key To Be A DVD (Or VCR) Key:

For example, to have the DSS control a TV, a Cable Converter, and two VCRs, you will need to re-assign the unused AUD key to operate the second VCR as follows:

1. Press and hold SET until the red light blinks twice, then release SET.