Philips REM110 Quick Features Setup Guide, Troubleshooting Problem Solution, VOL+,VOL- and Mute

QUICK FEATURES SETUP GUIDE

This guide is provided here for your convenience as a quick refer- ence for performing remote control sequences.

Component Setup

			x 2	# # # #
				x 2
Turn on	Press component		Press SET	Enter 4-digit code	Press POWER
component	key once	until Red Light		for your brand;	once; if no
(e.g., TV).	(e.g., TV).	blinks twice;		Red Light blinks	response,
			release SET .	twice after last #.	repeat steps
				with next code.
1	2		3	4	5
Auto Scan
			x 2		x 2
Turn on	Press component		Press SET	Aim remote at	Press SET
component	key once		until Red Light	component; press	until Red Light
(e.g., TV).	(e.g., TV).		blinks twice;	SCAN once. When blinks twice;
			release SET.	off, press any	release SET
* NOTE: Not VOL-, SCAN, or SET.				key* to stop.	to lock code.
1	2		3	4	5

Code Verification

x 2 x 2

Press component	Press SET	Enter 9-9-0;	Press 1 once for 1st digit.
key once	until Red Light	the Red Light	Wait 3 sec. and count blinks.
(e.g., TV).	blinks twice;	will blink twice.	Number of blinks equals
	release SET .		value of code digit.
			Repeat with 2, 3, and 4.
1	2	3	4
Volume Lock
		x 2
Press component*		Press SET	Press VOL+ once.
key once (e.g., CBL).		until Red Light	Volume now controlled
		blinks twice;	through component
* NOTE: Component must have		release SET.	selected in step 1.
volume capabilities.
1		2	3

7

TROUBLESHOOTING

PROBLEM:	SOLUTION:
Red Indicator Light does not	Replace the batteries with two
blink when you press a key.	(2) "AA" alkaline batteries (see
	Page 4).
The VOL+,VOL- and MUTE	Make sure that the volume con-
keys are not functional.	trol is locked to a component
	that has volume capabilities and is
	programmed into the remote
	control.
Red Indicator Light blinks when	Make sure you are aiming the
you press a key, but home enter-	remote control at your home
tainment component does not	entertainment component and
respond.	that you are within 15 feet of the
	component you are trying to
	control.
The remote control does not	Try all listed codes for the com-
control home entertainment	ponent brand being set up. Make
components or commands are	sure all components can be oper-
not working properly.	ated with an infrared remote
	control.
CH+, CH- and LAST do not	Due to an RCA design (1983-
work for your RCA TV.	1987), only the original remote
	control will operate these func-
	tions.
Changing channels does not	If original remote control
work properly.	required pressing ENTER to
	change channels, to change chan-
	nels, press ENTER on the
	remote after entering a channel
	number.
Tried Auto Scan and still could	Try Auto Scan again after clearing
not find a working code.	out the component key as fol-
	lows: Press and hold SET until
	Red Light blinks twice, then
	release. Next enter 9-9-2. Then
	press and release the component
	key to be cleared twice.

NOTE: To clear all set up codes and restore functions to Default, press SET until red light blinks twice, release SET and enter 9-8-1. Caution:When this clear feature is performed, please note that all of your set up codes will be reset to the default codes and you will need to reprogram components.

8