Programming Your Remote Control

Philips/Magnavox Components

The I-TV remote control can control up to six different components and is already pre-pro- grammed for use with newer Philips/ Magnavox audio/video equipment. Unless you want to change a factory setting,skip the programming instructions and simply start using your new remote control.

Programming Other Components

To control component brands other than Philips/Magnavox,you’ll need to perform the following steps to manually program the I- TV with codes listed under Manufacturer’s Codes on pages 14 through 19. Or as alterna- tive, you can use the Auto Scan feature, on page 6, to program your component codes.

The following chart lists the I-TV’s compo- nent keys and what type of device each key will control:

Key	Programmed To Control
TV	TV
VCR	VCR, DVD or LD Player
CBL	Cable Box
AUD	Amplifier, Tuner, Misc.Audio,
	or CD Player
DSS	Digital Satellite System
CD	CD Player,Amplifier, Tuner, or
	Misc.Audio

NOTE: If you want the component keys to control other types of devices, you’ll need to reassign the component keys. See page 7.

IMPORTANT: Please completely read and review the following steps before proceeding.We recommend highlighting the codes (starting on page 14) for the brands you wish to program or writing them down in the supplied chart.

Setup Codes For My Components

VCR

CBL

DSS

DVD

AUDIO

OTHER

To Manually Program The Remote Control:

NOTE: To program a TV/VCR Combo, skip these instructions and follow the steps on the next page.

1.Manually turn on a component (e.g.,TV, VCR,etc.) and,if applic- able,insert media (e.g.,cassette).

2.	On the remote con-
	trol, press a compo-
	nent key once (e.g.,
	TV, VCR, CBL, AUD, DSS, or CD).
3.	Press and hold SET (approx.
	5 seconds) until the red light
	blinks twice, then release SET.

4.Enter the first four-digit code for your brand of component. If performed correctly, the red light will blink twice.

5. Aim the remote control at the component and press POWER once. It should turn off. If it does not respond, repeat steps 2 and 3, trying each code for your brand until you find one that works. If it still does not work, try using Auto Scan (on page 6) to program your component.

6.Repeat steps 1 through 5 for each component you want to program into the I-TV remote control

NOTES: Press each key within 10 seconds of the previous entry. Otherwise,the remote con- trol will exit the programming mode.

If you press SET at any time (except during step 3), the remote control will exit the pro- gramming mode without saving your entries. You will have to start with step 1 to begin pro- gramming again.