Philips SRP2003/27 Cable box, satellite, Look up the 4-digit, If the red Setup, Aim the remote

5 sec.

CBL/SAT	Cable box, satellite
	receiver, Internet Protocol
	TV (IPTV), Free To Air TV,
	High Definition Television
	decoder (HDTV) and Tivo

Example: setting up the universal remote control to operate your TV:

1 Switch ON the TV manually or use the original remote control for this. Tune to channel 1.

2 Press and hold the

device selection key for 5 seconds until the red Setup light remains lit . The remote control is now in setup mode.

3Look up the 4-digit

code for your brand in the brand list at the back of this user manual.

A 4-digit code is shown for each brand. Use the digit keys

to enter the code for your brand (e.g. Philips,

	).
	• If the red Setup
	light turns off, an invalid code was
4	entered. In this case, try again.
	Aim the remote	5 - 60 sec.

control at the TV.

Press and hold the key. Release it immediately as soon the TV switches off.

•This step normally takes between 5 and 60 seconds. In extreme circumstances this step can take up to 15 minutes.

6EN

P2003_27__Manual_80_210.indd 6 25-09-09 11:0