Select menu display language, Setup network

Select menu display language

Note

•If this product is connected to a HDMI CEC compliant TV, skip this setting. It switches automatically to the same OSD menu language as per your TV setting (if the language set on TV is supported by this product).

1 In the Home menu, select [Settings] and press OK.

2	Select [Preference Setup], then press .
3	Select [Menu Language], then press .

•The language options may vary from different regions.

4Press to select a language, then press OK.

Setup network

To enjoy software updates of this product and BD- Live bonus contents for certain Blu-ray discs, set up the network connection.

Note

•Ensure that the network cable is properly connected and the router is switched on.

1 Connect this product to the broadband modem or router.

2In the Home menu, select [Settings] and press OK.

3Select [Advanced Setup], then press .

4Select [Network], then press OK.

5Select [Next] in the menu, then press OK.

»This product starts to detect if there is a connection to the network.

»If the connection test fails, select [Retry] and press OK to re-connect again to the network.

6Once connected, an IP address is obtained automatically.

•If no IP address is obtained, select [Retry] and press OK to try to obtain the IP address again.

7Select [Finish] in the menu, then press OK to exit.

Note

•This product does not support automatic detection of an Ethernet crossover cable.

•Loading BD-Live content from the internet may take some time, depending on the ﬁle size and the speed of the internet connection.

Use Philips EasyLink

This product supports Philips EasyLink which uses the HDMI CEC (Consumer Electronics Control) protocol. You can use one single remote control to control EasyLink-compliant devices that are connected through HDMI connectors.

Note

•To enable the EasyLink feature, you must turn on the HDMI CEC operations on the TV and on other devices connected to TV. Refer to the TVs/devices manual for details.

One-touch play

1Press the STANDBY button to turn on this product.

»The TV (if supports one-touch play) automatically turns on and switches to the correct video-in channel.

»If a disc is loaded in this product, disc play automatically starts.

One-touch standby

1Press and hold the STANDBY button for more than 3 seconds.

»All the connected devices (if the device supports one-touch standby) automatically switch to standby.

Note

•Philips does not guarantee 100% interoperability with all HDMI CEC devices.

12EN