Philips 9P5540C1, 9P6440C1, 9P6040C1 manual Select Channel Memory ADD/DELETE Channels control

FEATURE MENU CONTROLS (CONTINUED)

ADD/DELETE CHANNELS

Auto-Programming (see previous page) adds all the

channels it can find (on your Antenna or Cable TV system) into the TV's memory. Add/Delete Channels makes it easy for you to add other channels, or drop unwanted channels, from the list of channels in the TV's memory.

BEGIN

1Select CHANNEL MEMORY (ADD/DELETE CHANNELS) control.

With the FEATURES MENU on screen, move the RED highlight

with the MENU (M) buttons. Then press the MENU button.

2Press the CHANNEL ▲▼ or number buttons to select the channel you want to add or delete.

3Press the MENU ▶ button to ADD the channel into the TV's memory.

Press the MENU ◀ button to DELETE the channel from memory.

Repeat steps 2 and 3 for each channel you wish to add or delete.

4Press the STATUS or MENU button to clear the screen when through.

STOP

SMART HELP

Remember. You can also

add the AUX 1 VIDEO, AUX 2 VIDEO, AUX 1 Y PB PR, or SIDE VIDEO modes just like a channel. Then by pressing the CHANNEL ▲▼ buttons the AUX(iliary) mode can quickly be selected to use the desired set of Input jacks (see page 33).

Note: AUX(iliary) VIDEO modes are located between the lowest and highest channel numbers within the ADD/DELETE CHANNEL control screen.

MAIN MENU
PICTURE	SOUND
FEATURES	HELP
1ST TIME SETUP	EXIT

4

1 •		PLAY ▶		STATUS
CLEAR
REW		MENU
	−	M	+	FF
◀◀
				▶▶
				PAUSE II
MUTE		STOP	■	SURF	3
1	VOL			CH
ON/OFF		POS	SWAP	FREEZE	2
				SIZE
2 TUNER PIP		1	2	3
A◀ ◀ B

TV/VCR 4 5 6

ENTER

SLEEP 7 8 9

SMART0

POWER VCR ACC TV

M O D E

FEATURE MENU
PICTURE	CABLE
SOURCE	TUNING
CLOSED	CHANNEL
CAPTIONS	MEMORY
EXIT	MORE...
	1 OF 5

CHANNEL MEMORY
ADD/DELETE
CHANNELS
START
AUTO-PROGRAMMING
EXIT	HELP

ADD/DELETE CHANNEL

Channel 19 Added for ANT A

SELECT CHANNEL

to DELETE CHANNEL

AB for ANT B

M when FINISHED

NOTE: A separate ADD/DELETE CHANNEL memory may also be created for the ANT(enna) B Input on the rear of the set (if an Antenna or Cable TV signal has been connected). Just press the A◀ ◀ B button on the remote,

while in the ADD/DELETE CHANNEL mode, to switch between the ANT A and ANT B channel memory lists. Then follow steps 2 and 3 as shown to the left to add or delete the desired channels.

14