Philips bClever SV1 Maintenance, Lamp replacement, Remove the lamp door, using a screwdriver

Lamp

							STAND BY
MENU			OK
						PICTURE SIZE
		VOLUME +			BRIGHTNESS	CONTRAST	FREEZE
					PICTURE FORMAT COLOUR TRACKING		ZOOM
					DATA	S-VIDEO	VIDEO
PICTUREI	SIZEI –		PICTUREI	SIZEI +	KEY LOCK	AV MUTE	INFO
					MENU		OK
		VOLUME –
							KEYSTONE
						MUTE
	DATA	S-VIDEO	VIDEO
STANDBY
		SOURCE	AV MUTE

6. Maintenance >

When operation time reaches the last 100 hours of the average lamplife, the message ‘Warning: lamplife has almost expired’ will be displayed on the screen, each time the projector is switched on.

The lamplife remaining can be checked using the OSD menu.

1Press Menu.

–The menu bar appears on the screen.

2Use Cursor Control to select Lamp counter in the ‘Set up’ menu.

– The used lamplife hours are displayed.

Lamp replacement

MENU			OK
		VOLUME +
PICTUREI	SIZEI –		PICTUREI	SIZEI +
		VOLUME –
	DATA	S-VIDEO	VIDEO
STANDBY
		SOURCE	AV MUTE

–When the lamplife has expired the message ‘Warning: lamplife has expired’ is displayed on the screen.

1Switch off the projector and wait until the lamp has cooled down (about 5 minutes) before disconnecting the projector. Remove the mains lead from both projector and wall socket.

The mains lead must be disconnected from the projector otherwise the lamp door cannot be removed.

2Turn the projector over. Never place the projector on the side where the connections are located!

3Remove the lamp door, using a screwdriver.

–When the lamp door is removed the mains inlet socket will be partly closed. The lamp door

therefore cannot be removed if the mains lead is not disconnected from the projector.

4Read the caution and warning labels on the lamp holder.

Philips Multimedia Projector 32 English User guide bClever SV1