Indicators
No reaction when pressing keys on local keyboard or remote control
Picture too dark or bright with external monitor connected
7.Troubleshooting | > |
Standby/Remote control indicator (ring around Standby On button)
–red: Power/Standby mode.
–green: operation mode.
–green blinking (slow): warming up.
–red blinking (slow): cooling down.
• Do not switch the projector off; it will restart the lamp automatically within a few seconds.
–red/yellow blinking (slow) for 1 second: signal from remote control received in Power/Standby mode;
–green/yellow blinking (fast) for 1 second: signal from remote control received in operation mode.
Error indicator
–red: lamp error
–red blinking (fast): temperature error
–’Key lock’ active.
•Press Key lock on the remote control to switch off the Key lock function.
–’Monitor out’ has been enabled, but the external monitor is not correctly connected (the picture on both displays is too bright).
•Connect the VGA Y cable supplied (See ‘Connecting to an external monitor’ under ‘Installation’).
•If the VGA Y cable is correctly connected, verify whether the input impedance of the monitor is correctly set on 75 Ohm.
–’Monitor out’ has not been enabled, but the external monitor is connected (the picture on both displays is too dark).
•Enable the ’Monitor out’ option. Press Menu and use cursor control to go to ‘Set up’ in the menu bar. Select ’Monitor out’ and select ‘On’.
The Philips bClever SV1 projector uses three LCD (Liquid Crystal Display) panels.These panels contain a total of 1,200,000 pixels. As with any equipment, certain tolerances apply to the performance specification of the product. Philips’ specifications for defective pixels is very severe. Only one bright blue pixel is allowed. This pixel will not affect the overall picture quality or the life expectancy of the projector.
Philips Multimedia Projector | 36 | English User guide bClever SV1 |
|
|
|