Tips
Care of the screen | Clean the TV with a slightly damp soft cloth. Do not use abrasive solvent as it can | |
| damage the TV screen. | |
|
|
|
Poor Picture | • | Have you selected the correct TV system? |
| • Is your TV or house aerial located too close to loudspeakers, | |
|
| equipment or neon lights, etc.? |
| • | Mountains or high buildings can cause double pictures or ghost images. |
|
| Sometimes you can improve the picture quality by changing the direction of the |
|
| aerial. |
| • | Is the picture or teletext unrecognisable? Check if you have entered the correct |
|
| frequency. See Installation, p. 6. |
| • Are brightness, sharpness and contrast out of adjustment? Select Factory | |
|
| settings in the Setup, General menu, p. 8. |
| • | Sometimes poor picture quality is possible when having activated an |
|
| camera or camcorder connected to the right side of your TV and another |
|
| peripheral is connected to EXT 1, 2 or 3 at the same time. In this case switch |
|
| off one of the other peripherals. |
|
|
|
No picture | • | Is the aerial connected properly? |
| • | Are the plugs tightly connected in the aerial socket? |
| • | Is the aerial cable in good condition and does it have suitable plugs? |
| • Are the connection facilities to a possible second TV in good condition? If in | |
|
| doubt, consult your dealer. |
|
|
|
No sound | • | No sound on any channel? Check the volume isn’t at minimum. |
| • | Is the sound interrupted with the mute key ¬? |
|
| |
No solution found | Switch your TV off and then on again once. Never attempt to repair a defective | |
for your picture or | TV yourself. Check with your dealer or call a TV technician. | |
sound problem ? |
|
|
|
|
|
Remote control | • | If your TV no longer responds to the remote control, the batteries may be |
|
| dead. |
| • | Check if the remote control is in the correct mode. |
| • | You can still use the M key and the |
|
| |
Menu | Have you selected the wrong menu? Press the MENU key again to exit from | |
| the menu. | |
|
| |
NEXTVIEW | No NEXTVIEW info: | |
| See Acquisition and updating of NEXTVIEW information, p. 15. | |
| Displayed time is wrong: | |
| The broadcaster on programme number one does not transmit the correct local | |
| date and time. Use Reshuffle in the installation menu to place another broadcaster | |
| on programme number one. | |
|
| |
Standby | Your TV consumes energy in the standby mode. Energy consumption contributes | |
| to air and water pollution. | |
| Power consumption: 1 W. | |
|
|
|
21