6. Manual recording
General information
Use ‘Manual recording’ to make a spontaneous recording (for example, a programme currently being shown).
If you want to start and stop a recording manual- ly, read the section ‘Recording without auto-
matic switch-off’.
If you want to start a recording manually but have it stopped automatically, read the section
‘Recording with automatic switch-off’. (e.g.
not to record to the end of the tape)
Read the section ‘Automatic controlled recording from a satellite receiver (RECORD
LINK)’, if you want a recording to be controlled automatically by a satellite receiver.
Recording without automatic switch-off
1.Insert a cassette.
2.Use P+ 
P– or 0..9 to select the programme number you want to record, for example,
‘P01’. |
|
|
|
3.To start recording, press |
| . | |
REC I | |||
4.To stop recording, press |
|
| . |
STOP | |||
The message ‘PROTECTED CASSETTE CANNOT RECORD’ appears briefly on the screen, then the cassette is ejected.
A cassette without its security tab had been inserted. Cover the hole with adhesive tape or insert a new cassette.
Recording with automatic switch-off (OTR One-Touch-Recording)
1.Insert a cassette.
2.Use P+ 
P– or 0..9 to select the programme number you want to record.
3.Press REC I .
4.Each time you press REC I you will add 30 min- utes to the recording time.
5.To stop recording, press STOP
Preventing accidental erasing
All cassettes (except rental and
have a security tab on the back of the cassette. To prevent recording over important recordings (eras-
ing), you can remove this security tab.
If you later decide to record on a protected cas- sette, simply cover the hole with adhesive tape or slide the tab to the right.
Lining up recordings (assemble cut)
When you add a further recording to a cassette, which already has a recording on it, a short blank (flicker) can appear between the old and the new recording or the picture itself can flicker. To help reduce these from occurring, proceed as follows: 1.Find the tape position of the old recording
where you want to insert the new recording.
2.Look at the last minute of the old recording (playback).
3.Press STILL 2 at the tape position where the new recording is to go and press REC I .
4.Now start recording as usual by pressing 
on the remote control.
5.Stop recording with STOP
11 | EN |
|