7. Programming a recording (TIMER)
General information
Use a TIMER programming to automatically start and stop a recording at a later time or date. The
*the date you want to make the recording
*the programme number of the TV channel
*the start and stop time of the recording
*PDC on or off
This information is saved in a ‘TIMER’ block.
What is ‘PDC’?
‘PDC’ (Programme Delivery Control) is used to control the start and duration of TV channel recordings. If a TV programme starts earlier or ends later than scheduled, the
What do I need to know about ‘PDC’?
Usually the PDC time is the same as the start time. But if your TV guide shows a PDC time which is different from the programme’s sched- uled start time, e.g. 20.10 (PDC 20.14), you must enter the PDC time exactly to the minute. If you want a start time different from the PDC time, you must switch PDC off.
Programming a recording (with the VIDEO Plus+® system)
Thanks to this programming system, you no longer need to tediously enter the date, pro- gramme number, start and end time. All the information needed for programming is con- tained in the PlusCode number.
You can find this PlusCode number in most TV listing magazines written next to the concerned programme.
1.Press SV/V+ on the remote control.
Error message: ‘FULL’
•If this error message appears after pressing SV/V+ , then all TIMER blocks are already programmed. No more recordings can be programmed. If you want to clear a programmed recording (TIMER block), select the programme number on TIMER LIST menu and press CLEAR .
2.Enter the entire PusCode number. This num-
ber is up to 9 digits long and can be found next to the start time of the TV programme in your TV listing magazine. [e.g:
If you make a mistake, you can clear your input with CLEAR .
VIDEO Plus+ system
PlusCode No.
12345
SET=SV/V+
CORRECT=CLEAR
END=EXIT
3.Press SV/V+ .
4.Select ‘ONCE’, ‘DAILY’ or ‘WEEKLY’ recording with PLAY
FWD 1- B .
VIDEO Plus+ system
→ONCE
DAILY WEEKLY
SELECT K L CHOOSE B
END=EXIT
Selecting ONCE/DAILY/WEEKLY recordings ‘ONCE’: Recording once
‘DAILY’: Repeated daily recordings (Monday to Friday)
‘WEEKLY’: Repeated weekly recordings (every week on the same day)
5.The decoded data appears after confirmation.
You can go back to change the data. Select
the corresponding input field using FWD 1- B or CLEAR . Change the data with 0..9 .
13 | EN |
|