Digital Channel selection delay
Due to the tuning complexity of subchannel digital programming, the time to select and view a digital channel may take slightly longer than what the viewer is normally accustomed to (as compared to analog channel programs).
Digital channel broadcasts contain program and system data information that must be processed before the channel selection can be displayed.
Television installation
Channel search completed.
Digital channels found : | 0 |
Analog channels found : | 3 |
Finish
Channel tuning
Available channels:
-Cable (analog NTSC or digital QAM): max. from 1 to 135
-Antenna (analog NTSC or digital ATSC): max. from 2 to 69
If a tuned channel is not yet in the master channel map, the TV will attempt to tune the channel and it will be added to the map.
If the channel is not acquired, a message will appear that the channel is not available.
When you tune an
Subchannel selections
The new standards employed with digital broadcasting make it possible to receive multiple program channels under a single major channel number which can be selected by pressing the digit remote control
Tip:
After the installation of the TV channels has been done, always make a selection in the Installation menu between Antenna or Cable whether you want to watch Antenna TV channels or Cable TV channels.
If you make use of a signal splitter do not forget to put the switch in the corresponding position.
|
| Settings |
|
|
|
|
|
|
| Installation | 4 |
|
|
| Weak channel installation |
|
|
|
| ||||
|
| Language |
|
|
|
| 2 |
|
| Autoprogram |
|
|
|
| 3 |
|
| Weak channel installation |
|
|
| 4 | |
|
| Software upgrade |
|
|
|
| 5 |
|
|
|
|
|
|
| 6 |
|
|
|
|
|
|
| 7 |
|
|
|
|
|
|
| 8 |
|
|
|
|
|
|
| 9 |
This allows you to maximize the signal quality of weak channels by manually rotating the antenna.
Settings
|
| Installation | 4 |
|
|
| Software upgrade | 2 |
|
|
|
| |||||
|
| Language |
|
|
|
| Current software info |
|
|
| Autoprogram |
|
|
|
| Local upgrades/app... |
|
|
| Weak channel installation |
|
|
|
|
| |
|
| Software upgrade |
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
This allows you to upgrade new TV software if available.
8
Weak channel installation
This enables you to do a weak ATSC digital channel installation.This is only available for TV channels installed via an antenna connection (see section on Preparation, under Antenna).
&If a certain channel you expect to see is not tuned or is weak, you can install it manually. Call your local broadcasting station to check what channel is being transmitted to.
éSelect that channel in the displayed list of TV channels (in the antenna mode).
“The signal strength is displayed and updated continuously as you rotate the antenna.
Software upgrade
This menu allows you to upgrade your TV software using a USB device.
USB upgrade
It is possible to initiate an upgrade procedure from a USB portable memory. The memory device must be stored with the appropriate upgrade image (and structure) which can be found on the www.philips.com/usasupport website.
How to upload a new software version on your portable memory device, see Annex 1, under Philips TV software upgrade with portable memory.
Downloaded from www.Manualslib.com manuals search engine