Philips PRI920CI manual IMERACTlVE, Channel, ISTARTriME 0830 AMI

Page 20

U_ed along with the Clock fea- ure, you can select a specific

time the television will turn on when the Timer Active control is turned ON.

<_ Press the CLOCK button to display the Clock onscreen menu.

,_ Press the CURSOR UP • or CURSOR DOWN • button until the words START TIME are high-

I ghted.

<_ Enter the time to turn on the TV using the NUMBERED but- [ tons. If the first number is a single [digit first enter a zero then the digit

('.e., press ' 0 , then press 8 ).

_ Press the CURSOR RIGHT • or CURSOR LEFT • buttons to set either AM or PM time.

O

Remember: Be sure to set I the Timer Active to ON.

The onscreen menu will time out and disappear from the screen when you finish, or you can press the STATUS/EXIT button to clear the menu from the screen.

]IMER _	ON
CHANNEL	12
ISTART]qME	--:--AM I	]IMERACTlVE	ON
		CHANNEL	12

ISTART"riME 08:30 AMI

12

8:30

CHAf',QNG

TO_L6

IN 3[3 SECONDS

f

/

If the TV is in use when the START TIME control is about

to be activated, the screen will display a warning stating it's going to change channels in 30 seconds. It will appear like the screen shown below and change to lhe selected slari up channel, Pressing any button on the remote within this

count down will cancel the change.

20

Image 20

Contents Avox Safetysymbols SAFETYINSTRUCTIONS- Readbeforeoperatingequipment Setting the Language Control SettingIntroduction TVsYour Cable TV signal is a sin Wire 300 ohm, you first need to Round end of the antenna wire isIf your antenna has a Found Cable 75 ohm on the end, thenOn the VCR to the 75£2 plug on Remove the battery compart Ment lid on the back of the remoteCursor Buttons Clock ButtonThrough Ageenglish Toner Cable AutoprogramItuner TUI,,E-RAutoj Press the Menu button on SmaFtLockREVEVVBrightness Language Enish Tuner Cable Channb EditChannel Deleted MemorySrnartLockREVEVV BrightnessPress IllVolume Tint COL.TEMPNoisereduction OOL Temp Normal RamPress the Menu button on Or Cursor Leif buttons to activate or deactivate the NoiseTIMERACqqk on Cursor Down buttons untilT1MERACTIVE on CHANNEL12 Setclock 1000 AMI By pressing the Menu button thenNext Setcloo 10Q3 AMWntrdthe,tarte2inioeltYotLtoo ¢ Press the Clock button toISTARTriME 0830 AMI IMERACTlVEChannel Clock SetupRemote to display the onscreen 30 MIN 1OSECOFF TV-Y OFFTV-G OFF TV-MAPress the Cursor Down button until the words Change BlockOnIPeosshetSZAZwUcEeTthbeut IchangecodeSmartLock Access screen Enter the correct access code Press the Cursor UP or Cursor Down button untilPress the Cursor Right This point ALL the previouslyAVL Lighted, Press the CursorCursor UP or Cursor Use the Cursor Right or Cursor Left buttons onChangecode ImovieratingsONI Scroll the menu using Ursor UP or CursorParental Guidelines are Play SmartLock Disabled SmartLock Review will be high Ighted Press the Cursor RightIbassboost oal Press the Menu button on the remote to show the onscreenRIUH4h Cursor LEFTe or Se ected control or OFF GT5 @ Press the Smart Picture button on the remote control. Trebleboost on Bassboost on Iavloffi Sleeptimer OFF Press the Smart Sound butSmartLockI1 VoicePress the Channel + or To select a channel to add toPress the Surf button on Still displayed to ADD the channel to Surf listWork Programming The procedure of adding or deleting channel Beaumont/Austin Philips FactoryServiceof Georgia Philips FactoryService oflllinoisPhilips FactoryServiceof Texas 1110 N. Post Oak Rd., Suite Itasca, lLPage Color Television You