| yhur | Cable TV input into your |
|
| ome may be a single (75 |
| ohm) cable, or a Converter Box | |
| installation. In either case the | |
| connection to the TV is very easy. | |
| Just put the threaded end of the | |
| cable signal to the TWs antenna | |
| plug and screw it down tight, | |
_If |
| your Cable TV signal is a sin- |
| gle round cable (75 ohm) then | |
| you're ready to connect to the TV. | |
| if you have a Cable Converter | |
| Box: |
|
| Connect the Cable TV signal to the | |
| Cable Signal IN(put) plug on the | |
| Converter.. | |
<_ | Connect the Cable TV cable to the | |
| 75_ plug on the TV. | |
| If you have a Cable Converter Box: | |
| Connect the OUT(put) plug from the | |
| Converter to the 75[2 plug on the "IV. | |
O
Cable TV Company
Cable | TV Converter | Round | Cable |
Box | Connection | 75_ | Ohm |
Remember: | ! |
Set the TV | for the |
type signal | you've |
just,connected (see the Tuner' section
on page 11 of this manual.)
To select only the channel numbers on your Cable system see "Auto Program"
(page 12). If you use a Cable Converter
box, set the TV to the same channel as the converter's CH 3/4 switch (on the rear of the converter.)
Back of TV